DIY Reset TPMS Sensor Light on 2013-2017 Buick Encore

DIY Reset TPMS Sensor Light on 2013-2017 Buick Encore – The Opel Mokka is sold in the USA as Buick Encore. And while Opel presented the facelift version of the Mokka as “Mokka X” at the Geneva car salon at the beginning of March 2016, Buick now shows the freshened Encore at the New York International Auto Show. The Encore has developed off to Buick’s most important vehicle from the start. For the interior of the face lined Encore, Buick promises a higher-quality look through the use of better materials, setting bright accents and the use of contrast seams.

As a maximum trunk volume, Buick provides 1,371 liters for the Encore with folded seat backrests. The rear seat backrests can be folded in a ratio of 60 to 40. For convenience, a Bose sound system with anti-noise technology provides a standard to reduce unwanted cabin noise. For the revised Encore, a new 1.4-liter four-cylinder engine is available. The unit operates with direct injection and is coupled to a six-speed automatic transmission.

DIY Reset TPMS Sensor Light on 2013-2017 Buick Encore:

If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2013 2014 2015 2016 2017 Buick Encore, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2013, 2014, 2015 2016 2017 Buick Encore you must have a TPMS relearn tool and follow these steps:

  • Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
  • Turn the ignition to position On without starting the engine.
  • Press the DIC MENU button

  • Scroll up and select “Tire Pressure Menu”
  • Press the SET/CLR button
  • When a message requesting acceptance of the process appear, press the SET/CLR button again to confirm.
  • The horn sounds twice to signal the receiver is in relearn mode
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • After hearing the confirming horn chirp for the left rear tire, turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.

This procedure should be work on all generation of Buick Encore (2013 2014 2015 2016 2017 2018) model years. Hopefully the article of DIY Reset TPMS Sensor Light on 2013-2017 Buick Encore useful for you. Good Luck!

(Visited 75 times, 1 visits today)
Posted in Buick, Car Tagged with: , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*