How To Reset Cadillac CT6 TPMS Tire Pressure System Light (2016-2020)

Last Updated on February 12, 2020 by Christ

How To Reset Cadillac CT6 TPMS Tire Pressure System Light (2016-2020) – The Cadillac CT6 (which stands for Cadillac Touring 6) is a small family car segment F produced by Cadillac, coming to light in the New York International Auto Show in 2015 being the first automobile rear-wheel-drive developed by this brand after Cadillac Fleetwood was discontinued in 1996 and the first model with the new classification conducted by the board of Johan de Nysschen. This car is developed at the General Motors plant in Detroit / Hamtramck.

The CT6 is not considered the successor to the Cadillac XTS which exceeds 51 mm in outer length and 272 mm in the wheelbase. It is also the first car brand to use the Omega platform General Motors. There is no possibility of an 8-cylinder engine, including for the first time a V6 3.0-liter twin-turbo engine with 400 hp and 542 Nm with the implementation of a cylinder deactivation system. Other engines are 3.6-liter V6 and a turbocharged 2.0-liter 4-cylinder engine. Including the possibility of an all-wheel-drive and 8-speed automatic transmission.

How To Reset Cadillac CT6 TPMS Tire Pressure System Light (2016-2020)

Contents

How To Reset Cadillac CT6 TPMS Tire Pressure System Light (2016-2020)

If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your Cadillac CT6, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

Time Needed : 7 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn turning off or reset the Tire Pressure Monitoring System (TPMS) light on your Cadillac CT6 you must have a TPMS relearn tool follow these steps:

  1. Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.

  2. Place the vehicle in Service Mode by pressing and holding ENGINE START/STOP for more than five seconds

  3. Press the SEL button to enter the Settings page

    cadillac tpms tire pressure reset button

  4. Scroll down to INFO menu and press SEL button to select it

  5. Scroll to the TIRE PRESSURE screen

  6. Press and hold the SEL button until horn sounds

  7. Starting from the driver’s side front tire, place the TPMS RELEARN TOOL against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor until hearing the confirming horn chirp.

  8. Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.

  9. After hearing the confirming horn chirp for the left rear tire, turn the ignition to the OFF position. Adjust all tires to pressure listed on the tire placard.

Tools
  • TPMS RELEARN TOOL
Materials
  • Cadillac CT6

This tutorial is based on the Cadillac owner’s manual. This procedure should be work on the latest generation of Cadillac CT6 (2016 2017 2018 2019 2020 model years). Hopefully, the article How To Reset Cadillac CT6 TPMS Tire Pressure System Light (2016-2020) useful for you. Good Luck!

Name
Comment
(Visited 1,394 times, 1 visits today)

1 Comment on “How To Reset Cadillac CT6 TPMS Tire Pressure System Light (2016-2020)

  1. i have 2016 cadillac escalade all four tires gauge up still cant get prussure indicate light off what am i doing wrong. give me some tips give me some imformation.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.