2010 Ford Fusion Fuel Inertia Switch Reset Location

Last Updated on January 14, 2020 by Christ

2010 Ford Fusion Fuel Inertia Switch Reset Location – The Ford Fusion midsize car produced and sold in the US market by Ford since 2005. Despite having the same name as another model sold in Europe in the same period, it has nothing in common with the latter. The first series introduced the new family-feeling of the American Ford, equipped with a mask with three chrome bands plus two on the bumper.

At launch, it was sold in the fitting S, SE, and SE. The engine door was a 2.3 cc Duratec 161 hp, accompanied by a manual or 5-speed automatic, while the SE and SEL models were available 3.0 cc V6 Duratec 224 hp with 6-speed automatic transmission. The first series share some components with the Ford Mondeo, such as the seats and center console. The slogan of the Fusion in the US was “Life in Drive”, while in Canada it was “Create a Reaction”.

2010 Ford Fusion Fuel Inertia Switch Reset Location

2010 Ford Fusion Fuel Inertia Switch Reset Location:

Time needed: 7 minutes

Fuel pump shut-off (inertia) switch is a device that stops the fuel pump of the fuel delivery to the engine. If your engine cranks but does not start, this switch may have been activated. Here’s how to find and reset the switch:

  1. On the 2010 Ford Fusion, the fuel pump shut-off switch is located in the front passenger footwell area in the right upper corner. You will need to remove the lower scuff plate to access the switch.

    Fuel Inertia Switch Reset Location

  2. Make sure to turn off your vehicle

  3. Pushing in the Fuel pump shut-off (inertia) switch

  4. Turn the ignition to the on position and wait a few seconds and return the key to off position.

For more details, please watch the following video:

This tutorial is based on the Ford owner’s manual. This procedure works on a 2010 Ford Fusion that uses the 3.5L engine. Hopefully, the article of 2010 Ford Fusion Fuel Inertia Switch Reset Location useful for you.

(Visited 6,930 times, 1 visits today)

2 Comments on “2010 Ford Fusion Fuel Inertia Switch Reset Location

  1. My 2010 Ford Fusion SEL 3.0 does not have the switch in this location, and my car cranks but does not start. I’ve replaced the fuel pump already.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.