Reset Tire Pressure Sensor (TPMS) on 2008-2011 Chevy HHR

Reset Tire Pressure Sensor (TPMS) on 2008-2011 Chevy HHR – The HHR is a compact car produced by Chevrolet from 2006 to 2011. The name is acronym for Heritage High Roof. The model was offered only in the familiar version and small van, both four-door. Designed by designer Bryan Nesbitt, the line of the HHR had a decidedly retro. This style, previously, had already been taken by the Chrysler PT Cruiser. HHR was presented to the public at the Motor Show in Los Angeles in 2005, and has been marketed from model year 2006.

Smaller than the Equinox, the HHR shares the GM Delta platform with the Chevrolet Cobalt, Pontiac G5, Saturn Ion, and Saturn Astra. In Mexico, it was sold along with the Chevrolet Zafira, a minivan that was the source Opel. The model had the engine installed at the front and the drive at the front. The design of the HHR was inspired by the line of Chevrolet models of the mid-forties, especially the Chevrolet Suburban. The HHR has indeed in fact the large square fenders which were installed on the headlights, and an oval grille.

How to Reset Tire Pressure Sensor (TPMS) on 2008-2011 Chevrolet HHR:

To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2008, 2009, 2010, 2011 Chevy HHR you must have a TPMS relearn tool and follow these steps:

  • Turn the ignition to position On without starting the engine.
  • Press and hold unlock and lock buttons on the Remote Keyless Entry (RKE) transmitter until horn sounds
  • If your vehicle does not have Remote Keyless Entry (RKE) transmitter
    • Press the DIC MENU button on the turn signal lever
    • Scroll up and select “Tire Pressure Menu” by use the thumbwheel
    • Press the SET/CLR button
    • When a message requesting acceptance of the process appear, press the SET/CLR button again
      to confirm.
    • The horn sounds twice to signal the receiver is in relearn mode
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • Turn the ignition off and start the engine to verify the indicator has been reset.

For more details, please watch the following video:

This procedure should be work on all generation of Chevy HHR (2008, 2009, 2010, 2011) models. Hopefully the article of Reset Tire Pressure Sensor (TPMS) on 2008-2011 Chevy HHR usefull for you. Good Luck!

(Visited 9,380 times, 1 visits today)
Posted in Tips Tagged with: , ,
One comment on “Reset Tire Pressure Sensor (TPMS) on 2008-2011 Chevy HHR
  1. lilricky says:

    Whoever gave these HHR instructions never actually did the reset on a HHR. The HHR doesn’t have a MENU button the turn signal lever.

Leave a Reply

Your email address will not be published. Required fields are marked *

*