Resetting Tire Pressure (TPMS) Light on Dodge Challenger

Resetting Tire Pressure (TPMS) Light on Dodge Challenger – The Challenger is a car produced by the Dodge since 1970. The Dodge Challenger is one of the American muscle car known, and one of the latest pony car. He was born in 1970 in Challenger Six versions, V8 Challenger, Challenger T / A and Challenger R / T. The basic engine of a Dodge Challenger was a six-cylinder 3.7-liter engine, while the V8 version was equipped with an eight-cylinder 5.2-liter with dual carburetors capable of developing up to 230 hp (170 kW). reciprocating engines were the 5.6 or 6.3-liter V8.

The Challenger R / T was the most handsome and sporty version: it was equipped with engines from about 7 liters; of these the least developed powerful 335 hp (250 kW) and was equipped with 3-speed manual transmission. The other alternative engines developed 375, 390 and 425 hp. The Challenger went out of production in 1974 and was reproduced (with much less success) between 1978 and 1983. The frame recalls the one employed for the Plymouth Barracuda, but with a completely different body.

Resetting Tire Pressure (TPMS) Light on 2008-2016 Dodge Challenger:

If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2008 2009 2010 2011 2012 2013 2014 2015 2016 Dodge Challenger follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at least 25 km/h (16 mph), and then verify that it turns off.

Note: When filling warm tires, the tire pressure may need to be increased up to an additional 4 psi (30 kPa).

For more details, please watch the following video:

The procedure above can be applied to latest generations of Dodge Challenger (2008 2009 2010 2011 2012 2013 2014 2015 2016) models. Hopefully the article of Resetting Tire Pressure (TPMS) Light on Dodge Challenger useful for you. Good Luck! 😀

(Visited 9,337 times, 1 visits today)
Tagged with: , ,
5 comments on “Resetting Tire Pressure (TPMS) Light on Dodge Challenger
  1. mike thompson says:

    Did all required to reset the light, but it stays on with proper air pressure.

  2. SJK says:

    2012 challenger Same here

  3. ED GROTON says:

    I followed your instructions for resetting my TPMS,but the light continues to flash even after driving for 30 minutes. WHAT GIVES? I saw 4 reviews that your instructions did not work for them as well. 2010 challenger (all tires at 30psi).Have you ever done this before? If by chance I have a bad TPM sensor,how do I determine which wheel it is?

Leave a Reply

Your email address will not be published. Required fields are marked *


This site uses Akismet to reduce spam. Learn how your comment data is processed.