2014-2019 Buick LaCrosse TPMS Light Low Tire Pressure Warning Reset
Last Updated on November 1, 2020 by Christ
2014-2019 Buick LaCrosse TPMS Light Low Tire Pressure Warning Reset – The Buick LaCrosse is an E-segment car produced by Buick and Daewoo Motors under the US company General Motors. It replaced the Buick Century and Regal in North America from the year 2005.
Presented at the Los Angeles Auto Show in 2015, this new generation is mounted on the lightest P2XX platform shared with the 2018 Chevrolet Impala, which reduced its weight by approximately 136 kilos, despite growing slightly in length and width. Weight reduction was achieved by the integration of high strength steels and better sound-absorbing material.
2014-2019 Buick LaCrosse TPMS Light Low Tire Pressure Warning Reset:
If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2017 2018 2019 Buick LaCrosse follow these instructions:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).
Time needed: 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your Buick Lacrosse you must have a TPMS relearn tool and follow these steps:
- Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
- Turn the ignition to the ON position without starting the engine.
- Press the button to access the cluster app.
- Scroll up and select “Tire Pressure Menu”
- Press and hold the button
The horn sounds twice to signal the receiver is in relearn mode
- Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
- Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
- A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- Turn the ignition off and start the engine to verify the indicator has been reset.
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
This tutorial is based on the Buick owner’s manual. This procedure should be work on the latest generation of Buick LaCrosse (2014 2015 2016 2017 2018 2019 model years). Hopefully, the article of 2014-2019 Buick LaCrosse TPMS Light Low Tire Pressure Warning Resets useful for you. Good Luck!
Worked great except I had to start my 2018 LaCrosse and then follow your directions exactly. I just ordered the tool so I can reset my tires. Thanks so much!