How To Reset Nissan Fuga ECU Check Engine Warning Light
Last Updated on February 17, 2020 by Christ
How To Reset Nissan Fuga ECU Check Engine Warning Light – Fuga consists of Nissan Motor is manufactured in the Tochigi plant, which is a passenger car of the E segment class, which sells from 2004. In October 2004, as Cedric and Gloria successor car with a history of more than 40 years, primary Y50 type Fuga was released. Type in the six-generation later Cedric, but in the same way as of 7 generations later Gloria is “Y” has been adopted, the car name is changed to the new name “Fuga” in order to change the image of up to that of the Cedric / Gloria It has been.
In addition, similar to the Y34 type, which is the final type of Cedric / Gloria, in the North American market in addition to being sold as the “M” series of infinity ( “Q70” from the 2014 model year), with the same name in other Infiniti brand development area It has been sold. It should be noted that in the Chinese market has been this model will be released as the only “Fuga” outside of Japan in June 2005.
Contents
How To Reset Nissan Fuga ECU Check Engine Warning Light
Time Needed : 7 minutes
If you want to turn off or clear the Check Engine Light / ECU light in your Nissan Fuga, perform the following procedures within the specified time! Because timing is extremely critical.
Turn the ignition key to the ON position without starting the engine and wait 3 seconds.
Fully press and release the accelerator pedal five times within 5 seconds.
Wait 7 seconds
Fully depress the GAS pedal all the way to the floor and hold for ten seconds until the CEL starts blinking.
At this point, the light CEL should start flashing error code stored in the system and you can release the pedal. If you only get five flashes slowly or not flashing at all, then it is time You went on one of the above steps and you have to start from scratch.
Fully release the GAS pedal (while the CEL is still blinking) and wait about 10 seconds.
Fully depress the GAS pedal and keep it for more than 10 seconds.
Fully release the GAS pedal
The CEL light will continue to blink
Turn the ignition off and start the engine to verify the indicator has been reset.
Tools
- No Tool
Materials
- Nissan Fuga
For more details, please watch the following video:
Note: Repeat the process, if the lights still illuminate when you start the engine. Timing is EXTREMELY critical to resetting the ECU.
This tutorial is based on the Nissan manual guide. This procedure should be work on all generations of Nissan Fuga (2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article How To Reset Nissan Fuga ECU Check Engine Warning Light useful for you. Good Luck!
Leave a Reply