How To Reset Ford Edge TPMS Low Tire Pressure Light (2007-2019)
Last Updated on January 15, 2020 by Christ
How To Reset Ford Edge TPMS Low Tire Pressure Light (2007-2019) – Midsize SUV market which is currently occupied by the Toyota Harrier and Nissan Murano now gets new rivals from Ford with the latest models of the Ford Edge, which once introduced since 2006. This car became one of the Global Platform Ford products that will be sold worldwide. The front view of the car has a shape similar to the Ford Everest Concept, especially in the curve between the lights and front grille.
The exterior look of the Ford Edge 2015 equipped with some detailing that makes it look like a futuristic LED fog lamp with a tapered shape, the LED rear lights that are attached end-to-end and exhaust design trapezoidal like a sports car. The use of large black wheels also made to appear much more ferocious.
How To Reset Ford Edge TPMS Low Tire Pressure Light (2007-2019):
If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 Ford Edge, follow these instructions:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).
Time needed: 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. For that you need to purchase the correct TPMS reset tool and follow these instructions:
- Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
- Press and release the brake pedal.
- Turn the ignition from OFF to ON position three (3) times ending in the on position without starting the engine.
If your car has a Smart key button, press once to turn on, then press again to put the vehicle into ACC mode, then press again to turn the vehicle off. Repeat 2 more times, ending in ACC mode.
- Press the brake pedal again for 2 seconds, then release.
- Turn the ignition to OFF position (DO NOT remove the key)
- Turn the ignition from OFF to ON position three (3) times ending in the on position without starting the engine.
If your car has a Smart key button, press once to turn on, then press again to put the vehicle into ACC mode, then press again to turn the vehicle off. Repeat 2 more times, ending in ACC mode.
- If the reset mode has been entered successfully, the horn will sound once.
- Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
- Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
- A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- After hearing the confirming horn chirp for the left rear tire, training is completed and a message is shown in the information display. Turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.
For more details, please watch the following video:
We got this tutorial from Ford specialists. This procedure should be work on the latest generation of Ford Edge (2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article How To Reset Ford Edge TPMS Low Tire Pressure Light (2007-2019) useful for you. Good Luck!
Bonjour j`ai un ford Edge awd 2007 v6 et je voudrais savoir comment enlever l`icone allumé MOTEUR dans le tableau de bord, sans être obligé de payer.
Je vous remercie a l`avance et bien a vous.
Is the procedure to reset the banded sensors the same as the sensors in the valve stem . I have a 2008 Ford edge. Can new sensors be put in the new clamp and cradle and then be reset by just following that procedure?