How To Reset Buick Enclave TPMS Tire Pressure Light Reset (2008-2010)
Last Updated on June 4, 2020 by Christ
How To Reset Buick Enclave TPMS Tire Pressure Light Reset (2008-2010) – The model was launched in May 2007 for the 2008 model year. The Enclave, GMC Acadia, Chevrolet Traverse, and Saturn Outlook all share the Lambda platform of General Motors. The Enclave was first shown at the 2006 Detroit auto show as a concept car.
The Enclave, as a rule, can accommodate seven passengers. However, with an optional second row of seats consisting of a sofa that replaces the two single places, the habitability increases to eight seats. This optional is installed as standard on the front-wheel-drive versions but can be ordered on request on the all-wheel-drive models.
How To Reset Buick Enclave TPMS Tire Pressure Light Reset (2008-2010)
Time needed: 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. Follow the instructions below to reset the Tire Pressure Sensor Light on your Buick Enclave:
- Turn the ignition to the ON position without starting the engine.
If your car equipped with ignition button, press and hold the Start/Stop button for 5 seconds without touch the brake pedal
- Press and hold unlock and lock buttons on the Remote Keyless Entry (RKE) transmitter for 5 seconds
The horn will sound twice indicates the receiver is in relearn mode
- Increase/ decrease tire pressure for 5 seconds, starting from the driver’s side front tire (LF)
A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- Repeat the procedure on the Right-Front tire, the Right Rear tire, and the last one Left Rear tire.
During the final process (Left Rear Tire) the horn will sound two times to indicate the sensor identification code has been completed and the TPMS sensor matching process is no longer active.
- Turn off the ignition
Press the Start/Stop button once
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
Done!
This tutorial is based on the Buick Enclave owner’s manual. This procedure should apply to the first generation of Buick Enclave (2008 2009 2010 model years). Hopefully, the article How To Reset Buick Enclave TPMS Tire Pressure Light Reset (2008-2011) can solve your problem. Good Luck!
Worked like a charm on our 201p enclave.