2020-2021 Buick Encore GX TPMS Low Tire Pressure Sensor Light Reset

2020-2021 Buick Encore GX TPMS Low Tire Pressure Sensor Light Reset – The Buick Encore GX is a crossover-type car model built by Buick since 2019, which ranks between the smaller Encore and the larger Envision in the collection. It is based on the same base plate as the Chevrolet Trailblazer.

The Encore GX was unveiled at the Shanghai Motor Show in April 2019 along with the second-generation Encore. In the North American market, the model premiered at the Los Angeles Auto Show in November 2019.

2020-2021 Buick Encore GX TPMS Low Tire Pressure Sensor Light Reset

2020-2021 Buick Encore GX TPMS Low Tire Pressure Sensor Light Reset

Time needed: 17 minutes.

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your Buick Encore GX you must have a TPMS relearn tool and follow these steps:

  1. Turn the ignition to the ON position without starting the engine.

    If your car equipped with ignition button, press and hold the Start/Stop button for 5 seconds without touch the brake pedal

  2. Go to VEHICLE or INFO tab by pressing the SELECT button repeatedly

    The button is located on the turn signal lever
    tpms tire pressure light reset

  3. Scroll down and find the TIRE PRESSURE menu

    Use the band to scroll through the menu

  4. Press and hold the ✓ button

    The button is located on the end of the turn signal lever
    tpms tire pressure light reset

  5. If a confirmation message appears on the display, press the ✓ button again to confirm

    The TIRE LEARNING ACTIVE message will appears on the screen

  6. Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem.

    Then press the button to activate the TPMS sensor.

  7. Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.

    A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.

  8. Turn off the ignition

    Press the Start/Stop button once

  9. Adjust the tire inflation pressure recommended on the tire placard located on the door panel.

    Done!

Method 2:

The Tire Pressure sensor can also be reset using the following methods:

  • Turn the ignition to the ON position without starting the engine.
  • Go to VEHICLE or INFO tab by using ◄ ► navigation button
system reset
  • Scroll to the TIRE PRESSURE menu
  • Press and hold the thumbwheel button
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. 
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • Turn off the ignition 
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel. 

This tutorial is based on the Buick owner’s manual. This procedure should apply to the first generation of Buick Encore GX (2020 2021 model years). Hopefully, the article 2020-2021 Buick Encore GX TPMS Low Tire Pressure Sensor Light Reset can solve your problem. Good Luck!

Tagged with: , , , , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.