2015-2019 Citroën C-Elysée Low Tyre Pressure Sensor Light Reset
Last Updated on July 3, 2020 by Christ
2015-2019 Citroën C-Elysée Low Tyre Pressure Sensor Light Reset – Unveiled by Citroën on June 20, 2012, the second generation of C-Élysée presents itself as a saloon sedan which, like its cousin Peugeot 301, shares the same base as the Peugeot 208. Based on a wheelbase of 2.65 m for a total length of 4.44 m, it ceases to be specifically intended for the Chinese automobile market.
On November 14, 2016, it was presented in its restyled version. The grille widens and surrounds the projectors which are redesigned in chrome, the rear lights are 3D effect, and a new multimedia system appears inside.
Contents
2015-2019 Citroën C-Elysée Low Tyre Pressure Sensor Light Reset
Time needed: 7 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. Follow these steps to reset the Tire Pressure Monitoring Sensor (TPMS) light on your Citroën:
- Stop the vehicle in a safe place
Turn the engine switch off and engage the parking brake.
- Adjust the tire inflation pressure recommended on the tire placard
The tire placard located on the driver’s door panel
- Turn the ignition switch to the “ON” position without starting the engine
If your car equipped with ignition button, press the Start/Stop button twice without press the brake pedal
- Locate and press the tire SET button until an audible signal confirms the reinitialization
The button is located in the Glovebox
- Finally, turn the engine switch to the off position.
Done!
Method 2
Use this method, if your vehicle is equipped with a monochrome screen
- Stop the vehicle in a safe place and turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the middle pillar, driver’s side.
- Turn the engine switch to the “ON” position
- Press the MENU button on the audio system
- Access the “Personalisation configuration” menu
- Scroll down and select Define vehicle parameters
- Select the Tyre pressures
- Then select Reinitialisation and Confirm the instruction by pressing “Yes”
Method 3
Use this method, if your vehicle is equipped with a touchscreen display:
- Stop the vehicle in a safe place and turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the middle pillar, driver’s side.
- Turn the engine switch to the “ON” position
- Press the MENU button
- Select the DRIVING menu.
- In the secondary page, select “Under-inflation initialisation”.
- Confirm the instruction by pressing “Yes”
This tutorial is based on the Citroën owner’s manual. This procedure should apply to the second generation of Citroën C-Elysée (2015 2016 2017 2018 2019 model years). Hopefully, the article 2015-2019 Citroën C-Elysée Low Tyre Pressure Sensor Light Reset can solve your problem. Good Luck!
Leave a Reply