Reset TPMS Tire Pressure Sensor on 2011-2016 Chevy Volt

Reset TPMS Tire Pressure Sensor on 2011-2016 Chevy Volt – The Chevrolet Volt is an electric plug-in hybrid car segment C produced by General Motors with the Chevrolet brand and available in the US starting in December 2010. GM still avoids using the term “hybrid”, and prefers to call it electric car with extender of autonomy, since the drive motor is electric in every driving situation. March 5, 2012 has been elected Car of the Year 2012. The car features an aggressive body hatchback and a half elongated, slender and so sporty.

To give a touch of sportiness, think about elements such as the rear spoiler and a massive bumper, headlights sharp-cut, the lower pavilion and a short tail and collected. Moreover, the same height of the car body, very reduced, makes it even more appealing car already at one glance. The interior, suitable for four people, features a futuristic cockpit, as we can clearly see the complete absence of analog instruments. In place of the dashboard there is a digital display that provides information regarding speed and anything else you can detect by conventional analog dashboards of most of the other cars.

How to Reset TPMS Tire Pressure Sensor on 2011-2016 Chevy Volt:

If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2011 2012 2013 2014 2015 2016 Chevy Volt, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor need to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2011, 2012, 2013, 2014, 2015 2016 2017 Chevy Volt you must have a TPMS relearn tool and follow these steps:

  • Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
  • Turn the ignition to position On without starting the engine.
  • Press the DIC MENU button
  • Scroll up and select “Tire Pressure Menu”
  • Press the SET/CLR button
  • When a message requesting acceptance of the process appear, press the SET/CLR button again to confirm.
  • The horn sounds twice to signal the receiver is in relearn mode
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • Turn the ignition off and start the engine to verify the indicator has been reset.

For more details, please watch the following video:

This procedure should be work on latest generation of Chevy Volt (2011 2012 2013 2014 2015 2016 2017) model years. Hopefully the article of Reset TPMS Tire Pressure Sensor on 2011-2016 Chevy Volt usefull for you. Good Luck!

(Visited 3,959 times, 1 visits today)
Tagged with: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *


This site uses Akismet to reduce spam. Learn how your comment data is processed.