How To Reset Jeep Commander TPMS Tire Pressure Light (2006-2010)
Last Updated on December 30, 2019 by Christ
How To Reset Jeep Commander TPMS Tire Pressure Light (2006-2010) – Jeep product is indeed the impression grim and tough though of course it back to the tastes of each individual. Interestingly, Commander is also equipped with three sunroofs called Command View. Unfortunately, only one of these three sunroofs can be opened. There are three engine variants are provided Jeep. Commander Sport uses a 3.7-liter V6 engine while using the Commander Limited 4.7-liter V8 engine.
One variant again released by the name of Overland and use the Hemi V8 engine capacity of 5.7 liters. Excellence Hemi engine uses technology developed by Chrysler, is its ability to ‘turn off’ two to four cylinders when the car has driven in a constant velocity, thereby reducing fuel consumption. Commander uses a five-gear automatic transmission speed and is equipped with four-wheel drive although several sub-variants are also available in the two-wheel drive system.
How To Reset Jeep Commander TPMS Tire Pressure Light (2006-2010):
Time needed: 7 minutes
If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2005 2006 2007 2008 2009 2010 Jeep Commander, follow these instructions:
- Make sure the vehicle is at a complete stop
- Turn ignition to ON without starting the engine
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at least 25 km/h (16 mph), and then verify that it turns off.
Note: When filling warm tires, the tire pressure may need to be increased up to an additional 4 psi (30 kPa).
For more details, please watch the following video:
These instructions we got from the Jeep Commander owner’s manual. The procedure above can be applied to the old generations of Jeep Commander (2005 2006 2007 2008 2009 2010) models. Hopefully the article of How To Reset Jeep Commander TPMS Tire Pressure Light (2006-2010) useful for you. Good Luck! 😀
I did the above and the Service Tire Pressure System light is still on.
I did too an no use
Me too. Anyone know how to turn the light off after all four tires are properly inflated?
Hi does anyone know how to put a 2006 jeep commander in learning mode to reset the tires pressure so I can use the reset tool thanks my EMAIL is [email protected]
If you have not replaced your tpms sensor with a new one, and you get the warning light, and your tires are properly inflated you need to replace the battery in the sensor or perhaps the sensor itself.
How does one do that?
Walmart Auto Centers will replace the sensor for about $30.
Tried this method time and again. You can however take the vehicle to a reputable tire dealer. They have a meter the hold never to the tire to tell if the sensor is still operating in each tire. All mine are working. Still get the light. Lol!