Nissan Maxima Tire Pressure TPMS Warning Light Reset Procedure
Last Updated on December 17, 2019 by Christ
Nissan Maxima Tire Pressure TPMS Warning Light Reset Procedure – Various competition from various industries are now in 2015 and are indeed increasingly heated. One is the hot competition in the world automobile industry is now more stringent and clearer. One of them is Nissan has created a design for the Maxima sports sedan variant. To view the entire body as well as the exterior, the Nissan Maxima sedan looks very stylish. Coupled with the support of two exhaust luxury look behind the body of this sport sedan, the Nissan Maxima Sedan is obviously looking very strong and fantastic.
In terms of interior, Nissan Maxima Sport Sedan is equipped with a luxurious cabin that is made of a material that is a highly qualified choice. For entertainment, this car will also pin some advanced features such as infotainment systems that are directly supported by the advanced drive-assist display. For other features that are embedded in these tough car is sound Bose Audio System, cooling and heating that can be seen in the front seat, Intelligent Cruise Control, rear cross-traffic alert, skin Ascot and many other features that are very intriguing.
Nissan Maxima Tire Pressure TPMS Warning Light Reset Procedure:
To reset the Tire Pressure Monitoring System (TPMS) light on your 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 Nissan Maxima, follow these steps:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 25 mph.
If the above procedure does not work, try using the following procedure at your own risk!
Time needed: 17 minutes
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Locate the TPMS interface plug. This is a white female plug that is attached to the OBD II wire loom under the dash. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.
- Insert a paper clip or wire to the plug interface.
- Turn the ignition ON but do not start the engine
- Tap the end of the paper clip on any exposed ground (metal) 6 times.
- If the way you are correct, the TPMS warning light will start blinking slowly.
If it flashes fast that’s not right. If yours isn’t flashing slowly then check your connections, turn the ignition off and start over at step 4.
- Once you confirm the lights do not stop flashing, driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.
- The light will quickly come back on due to the low tire pressures. Refill your tires to the correct pressure.
For more details, please watch the following video:
We got this tutorial from Nissan specialists. The procedure above can be applied to the latest generations of Nissan Maxima ( 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 model years). Hopefully the article of Nissan Maxima Tire Pressure TPMS Warning Light Reset Procedure useful for you.
Leave a Reply