2003-2010 Hummer H2 Oil Life Oil Change Light Reset Guide
Last Updated on February 16, 2021 by Christ
2003-2010 Hummer H2 Oil Life Oil Change Light Reset Guide – The Hummer H2 (High Utility Maximum Mobility Easy Rider 2) is an SUV produced by Hummer between 2003 to 2010. It was built under contract by General Motors at a purpose-built factory in Mishawaka, Indiana.
The vehicle chassis is made up of 3 sections: the front uses a modified GMC 2500 chassis, the middle part was designed from scratch, while the rear area uses a modified GMC 1500 chassis. All of these three components are reinforced to withstand the weight of 2.7 tons unladen.
Contents
2003-2010 Hummer H2 Oil Life Oil Change Light Reset Guide
When the system has calculated that oil life has exceeded the specified service interval, a CHANGE ENGINE OIL SOON message will come on. You must perform an oil change on your vehicle and reset the system. Depending on your vehicle model, here are a few ways to reset the oil life light on 2003 2004 2005 2006 2007 2008 2009 2010 Hummer H2:
Easiest Way
Time needed: 7 minutes
The easiest way to reset the oil life on this vehicle is by pressing the accelerator pedal 3 times. Here’s how to do it:
- Place the ignition to the RUN position without starting the engine
If your vehicle has the keyless starting system, hold down the ENGINE START/STOP button without pressing the brake pedal
- Fully depress the GAS pedal, three times within 5 seconds
Don’t rush, make sure you press it fully
- Turn off the ignition
Press the ENGINE START/STOP button once
- Verify the indicator has been reset by starting the engine
Done!
2003-2007 Model Years
In addition to using the gas pedal, you can reset the oil life through the DIC button.
- Turn on the ignition without starting the engine
- Press the FUEL INFO button on the steering wheel briefly until “OIL LIFE REMAINING” appears on the screen
- Press and hold the ⏎ button until Oil Life 100% appears on the screen
- Verify the indicator has been reset by starting the engine
2008-2010 Model Years
- Turn on the ignition without starting the engine
- Press the VEHICLE INFO button briefly until “OIL LIFE REMAINING” appears on the screen
- Press and hold the ✓ button until Oil Life 100% appears on the screen
- Verify the indicator has been reset by starting the engine
These instructions are based on the Hummer H2 owner’s manual. This procedure should apply to the first generation of the Hummer H2 (2003 2004 2005 2006 2007 2008 2009 2010 model years). Hopefully, the article 2003-2010 Hummer H2 Oil Life Oil Change Light Reset Guide can solve your problem. Good Luck!
Leave a Reply