How To Reset GMC Yukon TPMS Tire Pressure Sensor Light (2015-2020)

Last Updated on May 30, 2020 by Christ

How To Reset GMC Yukon TPMS Tire Pressure Sensor Light (2015-2020) – The fourth-generation GMC Yukon was introduced in September 2013, went on sale in the first quarter of 2014. It is made in Arlington (Texas). The car is presented in the following versions of the usual GMC Yukon, extended Yukon XL, ordinary in luxury Yukon Denali and extended in luxury Yukon Denali XL.

GMC Yukon and Yukon XL received a new gasoline engine EcoTec3 5.3L V-8 FlexFuel (L83) with 356 hp and 519 Nm of torque. GMC Yukon Denali and Yukon Denali XL received a new petrol engine EcoTec3 6.2L V-8 FlexFuel (L86) with 420 hp and 610 Nm of torque.

How To Reset GMC Yukon TPMS Tire Pressure Sensor Light (2015-2020)

Contents

How To Reset GMC Yukon TPMS Tire Pressure Sensor Light (2015-2020)

Time needed: 17 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your GMC Yukon you must have a TPMS relearn tool and follow these steps:

  1. Stop the vehicle in a safe place

    Turn the engine switch off and engage the parking brake.

  2. Turn the ignition to the ON position without starting the engine.

    If your car equipped with ignition button, press and hold the Start/Stop button for 5 seconds without touch the brake pedal

  3. Go to INFO menu by using ◄ navigation button

    The button is located on the steering wheel
    oil life tire pressure tpms light reset

  4. Scroll to the TIRE PRESSURE menu

    Press the  button to enter the menu

  5. Press and hold the  button

    The horn sounds twice to signal the receiver is in relearn mode

  6. Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem.

    Then press the button to activate the TPMS sensor.

  7. Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.

    A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.

  8. Turn off the ignition

    Press the Start/Stop button once

  9. Adjust the tire inflation pressure recommended on the tire placard located on the door panel.

    Done!

Method 2:

  • Turn the ignition to ON position without starting the engine.
  • Turn the Trip knob until TIRE PRESSURE appears on the display.
gmc reset button
  • Press and hold the knob to select the menu
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • Turn off the ignition
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.

These instructions are based on the GMC Yukon owner’s manual. This procedure should apply to the fourth generation of the GMC Yukon (2015 2016 2017 2018 2019 2020 model years). Hopefully, the article How To Reset GMC Yukon TPMS Tire Pressure Sensor Light (2015-2020) can solve your problem. Good Luck!

(Visited 582 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.