How To Reset Ford Taurus TPMS Low Tire Pressure Light (2007-2019)
Last Updated on January 14, 2020 by Christ
How To Reset Ford Taurus TPMS Low Tire Pressure Light (2007-2019) – Pursuing a faster car on a freeway, so it is a tough job for the police team in America. Not just because the car speed violators were not reachable, as well as interceptors of the police car was not competitive. But now, police from California began to focus on looking for a vehicle with the best performance. The choice fell on a 2015 Ford Taurus, which had a fantastic performance. The car itself finally elected official vehicles as car interceptor California Police.
Earlier this car has been used by police in Los Angeles, in particular, the sheriff’s department. They do the testing and the results are quite satisfactory. This car is also claimed as the fastest interceptor car they can count on. Blue Opal alerts automobile manufacturers (Ford), it has a 6,000 cc engine with V8 engine configurations. In the segment of the capacity of such machines, Taurus is a car that has better acceleration speed. 5.7 seconds from rest to a point of reaching speeds of 100 kilometers per hour. With All-Wheel Drive (AWD), Taurus is able to achieve the power of 365 horsepower (hp).
Contents
How To Reset Ford Taurus TPMS Low Tire Pressure Light (2007-2019):
If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 Ford Taurus, follow these instructions:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).
2007-2016 Model Years
Time needed: 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. For that you need to purchase the correct TPMS reset tool and follow these instructions:
- Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
- Press and release the brake pedal.
- Turn the ignition from OFF to ON position three (3) times ending in the ON position without starting the engine.
If your car has a Smart key button, press once to turn on, then press again to put the vehicle into ACC mode, then press again to turn the vehicle off. Repeat 2 more times, ending in ACC mode.
- Press the brake pedal again for 2 seconds, then release.
- Turn the ignition to OFF position (DO NOT remove the key)
- Turn the ignition from OFF to ON position three (3) times ending in the ON position without starting the engine.
- If the reset mode has been entered successfully, the horn will sound once.
- Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
- Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
- A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- After hearing the confirming horn chirp for the left rear tire, training is completed and a message is shown in the information display. Turn ignition to OFF position. Adjust all tires to pressure listed on the tire placard.
For more details, please watch the following video:
This tutorial is based on the Ford owner’s manual. This procedure should be work on the latest generation of Ford Taurus (2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 model years). Hopefully, the article How To Reset Ford Taurus TPMS Low Tire Pressure Light (2007-2019) useful for you. Good Luck!
tried this method several times and no luck getting to horn honk reset mode