2008-2019 Ford Taurus Oil Change Minder Oil Life Light Reset Guide

2008-2019 Ford Taurus Oil Change Minder Oil Life Light Reset Guide – The Ford Taurus is a passenger car produced in three-generation by Ford from 1986 to 2019. The Taurus had a badge-engineered “twin” model, the Mercury Sable.

The restyling was revealed to the public at the Detroit Auto Show in 2009, while the press preview was held in Asheville, North Carolina, in June 2009. The Taurus scored high in driving tests, mainly thanks to its equipment.

2008-2019 Ford Taurus Oil Change Minder Oil Life Light Reset Guide

2008-2019 Ford Taurus Oil Change Minder Oil Life Light Reset Guide

Did you get a Engine Oil Change Due Next Service or Oil Change Required message on your 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 Ford Taurus? This means you must immediately perform oil change on your vehicle. Don’t forget to reset the oil minder system afterward. Depending on your vehicle model, here are a few ways to reset the oil life light.

5th Generation (2008-2009)

Time needed: 7 minutes.

The fifth generation of Ford Taurus was marketed from 2008 to 2009. Here’s how to reset the engine oil life on the Ford Taurus fifth generation.

  1. Turn on the ignition without starting the engine

    Make sure the vehicle completely stops

  2. Press the SETUP button briefly until “OIL LIFE =% HOLD RESET = NEW” appears on the screen

    The button is located on the steering wheel
    ford oil life change light reset

  3. Press the RESET button for 2 seconds and release to reset the oil life to 100%.

    Done!

6th Generation (2010-2019)

The sixth generation is the last models of the Ford Taurus in the US market. This generation was introduced since 2010 and got a facelift in 2013. Depending on your vehicle trim level, here are how to reset the engine oil life on the Ford Taurus sixth generation.

With Setup Button

Just like the previous generation, you can reset the oil by using the Setup and Reset buttons. But in this generation the button is located on the instrument panel. Here’s how to do it:

After turning on the ignition without starting the engine, press the SETUP button repeatedly until the “OIL LIFE % HOLD RESET = NEW” appears on the screen. Press and hold the RESET button for 2 seconds and release to reset the oil life to 100%.

ford oil change light reset

With Steering Control Button

For 2013 models and above, your vehicle is equipped with multi-information display and control buttons on the steering wheel. Here’s how to reset the engine oil life on the Ford Taurus:

  • Turn the engine switch to the “ON” position
  • Find the SETTINGS menu by using the ▲▼ navigation button and press the OK button to select
ford oil life change light reset
  • Select VEHICLE or CONVENIENCE (for some models don’t need to go through this menu)
  • Select OIL LIFE RESET
  • Press and holds the OK button until “Reset Successful” appears on the screen

These instructions are based on the Ford Taurus owner’s manual. This procedure should apply to the fifth and sixth generation of the Ford Taurus (2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 model years). Hopefully, the article 2008-2019 Ford Taurus Oil Change Minder Oil Life Light Reset Guide can solve your problem. Good Luck!

Tagged with: , , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.