2007-2011 Ford Crown Victoria TPMS Light Low Tire Pressure Reset
Last Updated on January 15, 2020 by Christ
2007-2011 Ford Crown Victoria TPMS Light Low Tire Pressure Reset – The Ford Crown Victoria is a car model of the US carmaker Ford, which was offered by the beginning of 1992 until the summer of 2011 in the North American market in the so-called full-size category. Unlike its main competitor, the Chevrolet Impala, which was sold mainly in North America, the Crown Victoria has been offered in addition to various markets such as Europe or the Middle East.
Crown Victoria is a traditional Ford model name, whose origins go back to the 1950s. Since 1996, vehicles of the type Crown Victoria in the Middle East are available. In Canada, the model was only used from 2000 only as a fleet vehicle and police and for individuals to buy. Even in the US, the Crown Victoria has not been sold to individuals since the end of 2007.
2007-2011 Ford Crown Victoria TPMS Light Low Tire Pressure Reset:
If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2007 2008 2009 2010 2011 Ford Crown Victoria, follow these instructions:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).
Time needed: 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. For that you need to purchase the correct TPMS reset tool and follow these instructions:
- Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
- Press and release the brake pedal.
- Turn the ignition from OFF to ON position three (3) times ending in the on position without starting the engine.
If your car has a Smart key button, press once to turn on, then press again to put the vehicle into ACC mode, then press again to turn the vehicle off. Repeat 2 more times, ending in ACC mode.
- Press the brake pedal again for 2 seconds, then release.
- Turn the ignition to OFF position (DO NOT remove the key)
- Turn the ignition from OFF to ON position three (3) times ending in the on position without starting the engine.
If your car has a Smart key button, press once to turn on, then press again to put the vehicle into ACC mode, then press again to turn the vehicle off. Repeat 2 more times, ending in ACC mode.
- If the reset mode has been entered successfully, the horn will sound once.
- Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
- Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
- A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- After hearing the confirming horn chirp for the left rear tire, training is completed and a message is shown in the information display. Turn ignition to OFF position. Adjust all tires to pressure listed on the tire placard.
For more details, please watch the following video:
We got this tutorial from Ford specialists. This procedure should be work on the latest generation of Ford Crown Victoria (2007 2008 2009 2010 2011 model years). Hopefully, the article of 2007-2011 Ford Crown Victoria TPMS Light Low Tire Pressure Resets useful for you. Good Luck!
Leave a Reply