2012 Ford Crown Victoria Fuel Inertia Switch Location
Last Updated on February 17, 2020 by Christ
2012 Ford Crown Victoria Fuel Inertia Switch Location – The Ford Crown Victoria is a full-size automobile from Ford (Sedan), manufactured by the Ford Motor Company in the United States. The first of these cars to go on the market was produced in 1955 in the United States. Initially, it was sold as a coupe, but in 1965 it started to be manufactured only in sedan until 2011.
It is a vehicle widely used in several cities in the United States as a taxi (the famous New York) and as a police car. In 2011 it stopped manufacturing because the United States legislation made mandatory the use of an electronic stability control system; Ford did not add, or equipment to the car with this equipment, did not want to why it had to stop manufacturing.
2012 Ford Crown Victoria Fuel Inertia Switch Location:
Time needed: 7 minutes
The fuel pump shut-off (inertia) switch is a device that stops the fuel pump of the fuel delivery to the engine. If your engine cranks but does not start, this switch may have been activated. Here’s how to find and reset the switch:
- On the Ford Crown Victoria (1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 model years), the fuel pump shut-off switch is located on the left side of the trunk behind the left rear tail light and the trunk liner.
- Make sure to turn off your vehicle
- Pushing in the Fuel pump shut-off (inertia) switch
- Turn the ignition to the ON position (Do not turn the ignition to ‘START) and wait a few seconds and return the key to off position.
Warning! Do not reset the fuel system shut-off switch if you see or smell fuel from the fuel system.
This tutorial is based on the Ford owner’s manual. This procedure works on a 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 Ford Crown Victoria that uses the Petrol engine. Hopefully, the article of 2012 Ford Crown Victoria Fuel Inertia Switch Location useful for you.
Leave a Reply