2008-2020 Chevy Suburban TPMS Tire Pressure Light Reset

2008-2020 Chevy Suburban TPMS Tire Pressure Light Reset – The Chevrolet Suburban, a large SUV, is one of the oldest cars of Chevrolet. The first version of the large and heavy car was already built-in 1935. He is still the largest series-produced SUV with up to 9 seats, and widely used police and the military vehicle in the US, where it was marketed as a GMC Suburban. In Australia, he was offered briefly as Holden Suburban.

In the 2010 model year in which the US News & World Report has chosen the Suburban as the best affordable SUV, a new premium interior package has been introduced, which includes three-zone climate control, Bluetooth and radio operation of the rear seats. All supplied as standard radio models have a USB port. The 6.0-liter engine is also suitable for E85. Finally, there were minor changes to the front of the vehicle, such as a slightly raised bumper. Side airbags were fitted as standard now.

 2008-2020 Chevy Suburban TPMS Tire Pressure Light Reset

2008-2020 Chevy Suburban TPMS Tire Pressure Light Reset:

Time needed: 17 minutes.

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your Chevy you must have a TPMS relearn tool and follow these steps:

  1. Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.

  2. Turn the ignition to the ON position without starting the engine.

  3. Press and hold unlock and lock buttons on the Remote Keyless Entry (RKE) transmitter until horn sounds

  4. If your vehicle does not have the Remote Keyless Entry (RKE) transmitter

    Press the  button to access the cluster app.
    Scroll up and select “Tire Pressure Menu”
    Press and hold the  button
    The horn sounds twice to signal the receiver is in relearn mode

  5. Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.

  6. Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.

  7. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.

  8. Turn the ignition off and start the engine to verify the indicator has been reset.

  9. Adjust the tire inflation pressure recommended on the tire placard located on the door panel.

For more details, please watch the following video:

This tutorial is based on the Chevrolet owner’s manual. This procedure should be work on the latest generation of Chevy Suburban (2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article of 2008-2020 Chevy Suburban TPMS Tire Pressure Light Reset useful for you. Good Luck!

Tagged with: , ,

1 Comment on “2008-2020 Chevy Suburban TPMS Tire Pressure Light Reset

  1. My 2008 Hyundai does all this BS by just add air to the tire that has the low pressure and bingo the light goes out. Your engineers should call Hyundai and ask for help.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.