2019-2020 VW Volkswagen Jetta TPMS Light Tire Pressure Sensor Reset
Last Updated on July 6, 2020 by Christ
2019-2020 VW Volkswagen Jetta TPMS Light Tire Pressure Sensor Reset – The Volkswagen Jetta VII is a sedan from the German automaker Volkswagen in segment C. It is the seventh generation Jetta and is offered in North America since 2018. Unlike the previous generation, this model is no longer offered in Europe. The car is built in the Mexican factory in Puebla.
For the first time, the Jetta is built on the Volkswagen Group’s modular transverse building block platform. However, at the beginning of its commercialization, only one transmission variant, the EA211, is offered. It is a 1.4-liter gasoline engine with 150 HP (110 kW) and a 250 Nm torque.
2019-2020 VW Volkswagen Jetta TPMS Light Tire Pressure Sensor Reset
Time needed: 7 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. Follow these steps to reset the Tire Pressure Monitoring System (TPMS) sensor on your Volkswagen Jetta:
- Make sure the vehicle is at a complete stop
Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard
The tire placard located on the driver’s door panel
- Turn the ignition to the ON position
Don’t start the engine
- Press the CAR button
The button is located on the audio display
- Tap SETTINGS or SETUP on the touchscreen to enter the Vehicle Settings menu
The menu is in the lower right corner
- Select TIRES
Tap the touchscreen to select
- Select SET
Tap the touchscreen to select
- When a confirmation message appears on the display, select CONFIRM to store the tire pressure
Done!
This tutorial is based on the Volkswagen owner’s manual. This procedure should apply to the seventh generation of Volkswagen Jetta (2019 2020 2021 model years). Hopefully, the article 2019-2020 VW Volkswagen Jetta TPMS Light Tire Pressure Sensor Reset can solve your problem. Good Luck!
Leave a Reply