How To Reset GMC Terrain TPMS Low Tire Pressure Light (2013-2017)

Last Updated on February 17, 2020 by Christ

How To Reset GMC Terrain TPMS Low Tire Pressure Light (2013-2017) – GMC Terrain is a medium-size crossover SUV (CUV) sold by General Motors under the GMC brand. Presented at the New York International Auto Show in 2009. It is GMC’s second CUV following full-size GMC Acadia, and it becomes the entry model of the same brand. In addition, it is also the de facto successor of Trent (Chevrolet Equinox Rivage), a medium-size CUV of Pontiac which was sold on the same body as on-frame medium-size SUV GMC Envoy and the same dealer network as GMC is there.

The platform adopts the same GM Theta platform as Chevrolet Equinox, Opel Antara, Cadillac SRX, etc. Initially, the engine has two types of inline 4 cylinders 2.4 L SIDI VVT and V type 6 cylinder 3.0 L SIDI VVT, which is combined with 6 speed AT. Drive system is FWD and AWD line up.

How To Reset GMC Terrain TPMS Low Tire Pressure Light (2013-2017)

How To Reset GMC Terrain TPMS Low Tire Pressure Light (2013-2017):

If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2012 2013 2014 2015 2016 2017 GMC Terrain, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

Time needed: 17 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2013 2014 2015 2016 2017 GMC Terrain you must have a TPMS relearn tool and follow these steps:

  1. Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.

  2. Turn the ignition to the ON position without starting the engine.

  3. Press the DIC MENU button

    gmc dic tpms reset button_

  4. Scroll up and select “Tire Pressure Menu”

  5. Press the SET/CLR button

  6. When a message requesting acceptance of the process appears, press the SET/CLR button again to confirm.

  7. The horn sounds twice to signal the receiver is in relearn mode

  8. Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.

  9. Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.

  10. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.

  11. Turn the ignition off and start the engine to verify the indicator has been reset.

This tutorial is based on the GMC owner’s manual. This procedure should be work on the first generation of GMC Terrain (2013 2014 2015 2016 2017) model years. Hopefully the article of How To Reset GMC Terrain TPMS Low Tire Pressure Light (2013-2017) useful for you. Good Luck!

(Visited 4,534 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.