How To Reset Chevy Cruze TPMS Tire Pressure Sensor Light (2012-2019)
Last Updated on October 18, 2020 by Christ
How To Reset Chevy Cruze TPMS Tire Pressure Sensor Light (2012-2019) – The Chevrolet Cruze is an average car produced since 2009 by the Korean automaker Daewoo (now GM Korea as part of the US group General Motors). The car replaces the Chevrolet Lacetti in Europe, while in the Asian markets is sold under the name Daewoo Lacetti Premiere and Australia is known as the Holden Cruze.
The new world car in addition to adopting a single designation depending on the manufacturer brand has been designed on a totally new platform (chassis Delta II) developed by the Opel engineers to fit even on the fourth generation of the Astra. The design anticipates the lines of future cars of the mark, characterized by a frontal angular equipped with a large mask, elusive headlights, and ribs on the hood.
How To Reset Chevy Cruze TPMS Tire Pressure Sensor Light (2012-2019):
If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2012 2013 2014 2015 2016 2017 2018 2019 Chevy Cruze, follow these instructions:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).
Time needed: 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your Chevy you must have a TPMS relearn tool and follow these steps:
- Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
- Turn the ignition to the ON position without starting the engine.
- Press and hold unlock and lock buttons on the Remote Keyless Entry (RKE) transmitter until horn sounds
- If your vehicle does not have the Remote Keyless Entry (RKE) transmitter
Press the button to access the cluster app.
Scroll up and select “Tire Pressure Menu”
Press and hold the button
The horn sounds twice to signal the receiver is in relearn mode
- Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
- Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
- A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- Turn the ignition off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
For more details, please watch the following video:
This tutorial is based on the Chevrolet owner’s manual. This procedure should be work on the latest generation of Chevy Cruze (2012 2013 2014 2015 2016 2017 2018 2019 model years). Hopefully, the article How To Reset Chevy Cruze TPMS Tire Pressure Sensor Light (2012-2019) useful for you. Good Luck!
Leave a Reply