How To Reset Oil Change Minder Oil Life Light on Ford Explorer (2006-2021)

Last Updated on September 29, 2020 by Christ

How To Reset Oil Change Minder Oil Life Light on Ford Explorer (2006-2021) – This car is an SUV manufactured by Ford since 1990. The Explorer and the Mountaineer were revised in 2006. A new chassis manufactured by Magna International was used, which replaced the one manufactured by Tower Automotive.

There were two engines available, a V6 with 4 L displacement and 210 HP of power, and a V8 with 4.6 L, 24 valves, and 292 HP. The latter, which was at the top of the range, was similar to the power unit mounted on the Mustang’s fifth generation.

How To Reset Oil Change Minder Oil Life Light on Ford Explorer (2006-2021)

Did you get a Engine Oil Change Due Next Service or Oil Change Required message on your 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 Ford Explorer? This means you must immediately perform oil change on your vehicle. Don’t forget to reset the oil minder system afterward. Depending on your vehicle model, here are a few ways to reset the oil life light.

4th Generation (2006-2010)

The fourth generation of Ford Explorer was marketed from 2006 to 2010. There are two ways to reset the oil life in this generation. Depending on your vehicle trim level, here are how to reset the engine oil life on the Ford Explorer fourth generation.

With Trip Button

With Driver Controls Button

• Turn on the ignition without starting the engine
• Press the SETUP button briefly until “PRESS RESET TO BEGIN SYSTEM CHECK” appears on the screen

• Press RESET button to enter the SYSTEM CHECK menu
• Display “HOLD RESET IF NEW OIL” by using RESET button
• Press the RESET button for 2 seconds and release to reset the oil life to 100%.

5th Generation (2011-2019)

The fifth generation of Ford Explorer was marketed from 2011 to 2019. Here’s how to reset the engine oil life on the Ford Explorer fifth generation.

• Turn the engine switch to the “ON” position
• Find the SETTINGS menu by using the ▲▼ navigation button and press the OK button to select

• Select VEHICLE
• Select OIL LIFE RESET
• Press and holds the OK button until “Reset Successful” appears on the screen

6th Generation (2020-2021)

The sixth generation is today’s latest models, this generation was introduced since 2020. Depending on your vehicle trim level, here are how to reset the engine oil life on the Ford Explorer sixth generation.

With 4 Inch Display Menu

• Turn the engine switch to the “ON” position
• Find the INFORMATION menu by using the ▲▼ navigation button

• Press the menu button to display the submenu
• Scroll down and select OIL LIFE
• Select OIL LIFE RESET
• Press and holds the OK button until oil life display changes to 100%

With 6 and 12 Inch Display Menu

1. Turn the engine switch to the “ON” position
2. Press the menu button to enter the main menu
3. Find the SETTINGS menu by using the ▲▼ navigation button and press the OK button to select
4. Select OIL LIFE RESET
5. Press and holds the OK button until oil life display changes to 100%

These instructions are based on the Ford Explorer owner’s manual. This procedure should apply to the fourth, fifth, and sixth generation of the Ford Explorer (2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 model years). Hopefully, the article How To Reset Oil Change Minder Oil Life Light on Ford Explorer (2006-2021) can solve your problem. Good Luck!