Easiest Way To Reset Oil Change Light on Chrysler Sebring (2007-2010)
Last Updated on November 22, 2020 by Christ
Easiest Way To Reset Oil Change Light on Chrysler Sebring (2007-2010) – The Sebring is a car produced by Chrysler from 1995 to 2010. It was built in five series: FJ, JX, ST-22, JR, and JS. The FJ series, produced from 1995 to 2000, and ST-22, produced from 2000 to 2005, were presented only in coupé version.
The JX series, on the market from 1996 to 2000, was only available in a cabriolet version. On the market from 2001 to 2006, the JR series and JS presented the last series in 2007. These series were produced in both the 4-door hatchback and “convertible” (cabriolet) versions.
Easiest Way To Reset Oil Change Light on Chrysler Sebring (2007-2010)
Time needed: 7 minutes
When you exceed the next scheduled oil change interval, the Oil Change Required light will display in the screen. This indicator system must be reset after performed the maintenance on your vehicle. The fastest way to reset the oil light on the Chrysler Sebring is by pressing the gas pedal. Here’s how to get started:
- Place the ignition to the RUN position without starting the engine
If your vehicle has the keyless starting system, press the ENGINE START/STOP button twice without pressing the brake pedal
- Fully depress the GAS pedal, three times within 10 seconds
Don’t rush, make sure you press it fully
- Turn off the ignition
Press the ENGINE START/STOP button once
- Verify the indicator has been reset by starting the engine
Done!
These instructions are based on the Chrysler Sebring owner’s manual. This procedure should apply to the third generation of the Chrysler Sebring (2007 2008 2009 2010 model years). Hopefully, the article Easiest Way To Reset Oil Change Light on Chrysler Sebring (2007-2010) can solve your problem. Good Luck!
Leave a Reply