Reset Guide: Genesis G90 Wrench Service Light (2017-2019)
Last Updated on January 3, 2021 by Christ
Reset Guide: Genesis G90 Wrench Service Light (2017-2019) – The Genesis G90 is a passenger car produced by the Korean car manufacturer Genesis Motor since 2016. It was presented at the 2016 North American International Auto Show.
The car is a high-end 3-volume sedan, with the classic front / longitudinal engine setup and rear-wheel drive. Engines available are a turbocharged 3.3-litre V6, naturally aspirated 3.8-liter V6 and a 5.0-litre V8. The transmission is entrusted to an 8-speed automatic transmission.
Reset Guide: Genesis G90 Wrench Service Light (2017-2019)
Time needed: 7 minutes
The service light will flash each time you turn on the ignition when your vehicle exceeds the specified service interval. The service interval must be adjusted after performed maintenance on your vehicle. Here is how to reset the service light on 2017 2018 2019 Genesis G90:
- Place the ignition to the ON position without starting the engine
If your vehicle has the keyless starting system, press the ENGINE START/STOP button twice without pressing the brake pedal
- Go to the ⚙️ USER SETTINGS mode by pressing the ❐ MODE button repeatedly
The button is located on the steering wheel
- Find and select SERVICE INTERVAL
Use the navigation switch to scroll and press OK button to enter the menu
- Make sure you activate the service interval function by giving a check mark
In this menu you can set a maintenance reminder at a specific interval by adjust the Time or Distance
- Use the navigation switch to change the digit value. Press the OK button to confirm the changes.
Done!
These instructions are based on the Genesis G90 owner’s manual. This procedure should apply to the first generation of the Genesis G90 (2017 2018 2019 model years). Hopefully, the article Reset Guide: Genesis G90 Wrench Service Light (2017-2019) can solve your problem. Good Luck!
Leave a Reply