2010-2011 Mercury Milan Engine Oil Life Light Reset Guide

Last Updated on October 22, 2020 by Christ

2010-2011 Mercury Milan Engine Oil Life Light Reset Guide – The Milan is a mid-size car produced by Mercury from 2005 to 2010 only in a four-door sedan version. The model was based on Ford’s CD3 platform. The Milan was essentially the sister car of the Ford Fusion sold in America and was placed under the more luxurious Lincoln MKZ.

Milan was presented to the public at the Chicago Motor Show and was sold in the United States, Mexico and the Middle East. It was produced from August 1, 2005, to December 17, 2010, in Hermosillo, Mexico. The model went out of production following the suppression of the Mercury brand.

2010-2011 Mercury Milan Engine Oil Life Light Reset Guide

2010-2011 Mercury Milan Engine Oil Life Light Reset Guide

Time needed: 7 minutes

Did you get a Change Oil Soon or Oil Change Required message on your 2010 2011 Mercury Milan? This means you must immediately perform oil change on your vehicle. Don’t forget to reset the oil minder system afterward. Depending on your vehicle model, here are a few ways to reset the oil life light.

  1. Turn on the ignition without starting the engine

    Make sure the vehicle completely stops

  2. Press the SETUP button briefly until “OIL LIFE % HOLD RESET = NEW” appears on the screen

    The button is located on the steering
    ford oil change light reset

  3. Press the RESET button for 2 seconds and release to reset oil life to 100%

    Done!

These instructions are based on the Mercury Milan owner’s manual. This procedure should apply to the first generation of the Mercury Milan (2010 2011 model years). Hopefully, the article 2010-2011 Mercury Milan Engine Oil Life Light Reset Guide can solve your problem. Good Luck!

(Visited 229 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.