2006-2011 Mercury Grand Marquis Engine Oil Life Light Reset Guide
Last Updated on October 21, 2020 by Christ
2006-2011 Mercury Grand Marquis Engine Oil Life Light Reset Guide – The Grand Marquis is a full-size luxury rear-wheel drive passenger car produced by Mercury from 1983 to 2011. It was the flagship of the Mercury range.
The Grand Marquis was primarily produced in St. Thomas, Canada. From 1983 to 1985 it was instead made in Saint Louis, Missouri. During the years it was built, the Grand Marquis, in addition to being sold in North America was mainly exported to the Middle East.
2006-2011 Mercury Grand Marquis Engine Oil Life Light Reset Guide
Time needed: 7 minutes
Did you get a Change Oil Soon or Oil Change Required message on your 2006 2007 2008 2009 2010 2011 Mercury Grand Marquis? This means you must immediately perform oil change on your vehicle. Don’t forget to reset the oil minder system afterward. Depending on your vehicle model, here are a few ways to reset the oil life light.
- Turn on the ignition without starting the engine
Make sure the vehicle completely stops
- Press the SETUP button briefly until “OIL LIFE START VALUE PRESS SELECT TO CHANGE” appears on the screen
The button is located on the instrument panel
- Press SELECT button
OIL LIFE START VALUE SET TO % will be displayed
- Press the RESET button for 2 seconds and release
OIL LIFE – PRESS RESET IF NEW OIL message will appears on the display
- Press and hold the RESET button again to reset oil life to 100%
Done!
These instructions are based on the Mercury Grand Marquis owner’s manual. This procedure should apply to the fourth generation of the Mercury Grand Marquis (2006 2007 2008 2009 2010 2011 model years). Hopefully, the article 2006-2011 Mercury Grand Marquis Engine Oil Life Light Reset Guide can solve your problem. Good Luck!
Leave a Reply