How To Reset Toyota Sienna Power Liftgate Trunk Door (2012-2020)

Last Updated on February 17, 2020 by Christ

How To Reset Toyota Sienna Power Liftgate Trunk Door (2012-2020) – Sienna is a minivan manufactured and sold by Toyota Motor Corporation in North America. It exists in Japan as a small number in the form of parallel imports.

The engine is a combination of 2 6R, “2GR-FE” of 269PS and 2.7L · 4 “1AR-FE” of 189PS installed in Venza, both of which are combined with 6AT. Both engines can be selected from 2WD and AWD as the driving method. The size got even bigger, with a total length of 5,085 mm full width 1,986 mm total height 1,750 mm, wheelbase 3,030 mm.

How To Reset Toyota Sienna Power Liftgate Trunk Door (2012-2020)

How To Reset Toyota Sienna Power Liftgate Trunk Door (2012-2020):

Time needed: 3 minutes

If you have issues with the Liftgate / Trunk Door and want to reset it, you can be set to open to a specific height by performing the following step:

  1. Open the liftgate using the switch or the Intelligent Key and adjust it to the desired position.

  2. While holding the liftgate in position, press and hold the power back door switch located on the liftgate until 4 beeps are heard.

  3. The liftgate will open to the selected position setting.

For more details, please watch the following video:

Repeat these steps for setting the position of the liftgate if you want to change the position of the liftgate.

This tutorial is based on the Toyota owner’s manual. The procedure above can be applied to the latest generations of Toyota Sienna (2012 2013 2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article How To Reset Toyota Sienna Power Liftgate Trunk Door (2012-2020) useful for you.

(Visited 2,296 times, 1 visits today)

1 Comment on “How To Reset Toyota Sienna Power Liftgate Trunk Door (2012-2020)

  1. My 2014 Toyota Sienna power liftgate will close fine using button on liftgate and also will CLOSE using the inside switch. My continued issue is that the inside switch will NOT OPEN the liftgate no matter what I try doing. It unlatches the liftgate, starts to lift, then gives two beeps and closes the electric latch again. I have to get out press the button above license plate and manually lift the gate.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.