How to Check Ford F250 Fuel Inertia Switch Location
Last Updated on February 17, 2020 by Christ
How to Check Ford F250 Fuel Inertia Switch Location – The conventional F-250, 350 was one of the F series variations sharing the body panel with the F150, but in 1999 it appeared as an independent model of a unique body that is one size larger. Compared to the F-150, suspensions and the like were strengthened, and also a lineup of V – type 10 cylinder engine and diesel cars.
The 43rd president of the United States of America George W. Bush owns this first Super Duty F-250 in a villa in Texas. A minor change was implemented in 2005. The mechanism was changed mainly, the 7.3 L diesel car was abolished.
How to Check Ford F250 Fuel Inertia Switch Location:
Time needed: 7 minutes
The fuel pump shut-off (inertia) switch is a device that stops the fuel pump of the fuel delivery to the engine. If your engine cranks but does not start, this switch may have been activated. Here’s how to find and reset the switch:
- On the 2000-2007 Ford F-250, the fuel pump shut-off switch is located in the passenger’s footwell, by the kick panel. May you need to remove the lower scuff plate to access the switch.
- On the 2008-2010 Ford F-250, This switch is located on the passenger’s side of the instrument panel. Open the front passenger door and remove the small access panel.
- Make sure to turn off your vehicle
- Pushing in the Fuel pump shut-off (inertia) switch
- Turn the ignition to the ON position (Do not turn the ignition to ‘START) and wait a few seconds and return the key to off position.
For more details, please watch the following video:
Warning! Do not reset the fuel system shut-off switch if you see or smell fuel from the fuel system.
This tutorial is based on the Ford owner’s manual. This procedure works on a 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 Ford F250 that uses the Petrol engine. Hopefully, the article of How to Check Ford F250 Fuel Inertia Switch Location useful for you.
Looking for where the nurse switch is on a 2018 F3 50
What would shut down both the starter and the fuel pump after setting for 6 weeks?
2002 f250 will crank but wont start i check 1st by shooting starting fluid in the intake and it started shop says its my pcm but im leary of that cause if it starts with starting fluid would it be the Fuel Inertia Switch needs to bee checked also i dont get codes when i check is it the pcm
Try the shut-off (inertia) switch I have a 04 f250 and mine did the same thing and that’s what it was hop this is helpful