2016-2020 Opel Astra GTC TPMS Tyre Pressure Sensor Light Reset

Time needed: 17 minutes

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor needs to be reset. For that you need to purchase the correct TPMS reset tool and follow these instructions:

1. Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.

2. Turn the ignition to the ON position without starting the engine.

3. Set the selector lever to neutral, for vehicles with manual transmission

   Set the selector lever to P, for vehicles with automatic transmission
4. Select the Vehicle Information Menu by using the MENU button on the turn signal lever

5. Scroll down and select Tyre Pressure menu

6. Press and hold SET/CLR button to reset TPMS

7. Press the SET/CLR button again to confirm the selection. If the reset mode has been entered successfully, the horn will sound once.

8. Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.

9. Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.

10. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.

11. After hearing the confirming horn chirp for the left rear tire, training is completed and a message is shown in the information display.

12. Turn ignition to OFF position and then Adjust all tires to pressure listed on the tire placard.