2016 SEAT Ateca Tyre Pressure Monitoring System Light Reset

2016 SEAT Ateca Tyre Pressure Monitoring System Light Reset – The SEAT Ateca is an all-car segment C that the Spanish brand SEAT began to be commercialized in the second quarter of 2016. It is the first SUV of the brand, being located above the SEAT Arona. Its name comes from the Spanish municipality Ateca within the Community of Calatayud, in the province of Zaragoza, Aragon. It is a long awaited model for SEAT after years of development and after presenting prototypes such as the SEAT Tribu (2007), SEAT IBX (2011) and SEAT 20v20 (2015), finally, SEAT puts on sale its first SUV.

The SEAT Ateca (model KH7 / 575) was officially presented to the press on February 10, 2016, and its official debut at the Geneva Motor Show in 2016, to be marketed from April to May. The model uses the same MQB platform used by the third generation SEAT León, which has a very similar equipment.

2016 SEAT Ateca Tyre Pressure Monitoring System Light Reset:

If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2016 2017 SEAT Ateca, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Turn the ignition to ON position without starting the engine.
  • Press CAR button
  • Tap SETUP on the touchscreen to enter the Vehicle Settings menu
  • Select TIRES

  • Tap SET button on the touchscreen

  • Select CONFIRM to store the tire pressure

  • Driving for a few miles (kilometers), calibration will complete after 20 minutes of normal driving

If your vehicle not equipped with Easy Connect Audio system, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Turn the ignition to ON position without starting the engine.
  • Locate and press the SET button on the center console until you hear an audible signal

This procedure should be work on the latest generation of SEAT Ateca (2016 2017 2018) model years. Hopefully, the article of 2016 SEAT Ateca Tyre Pressure Monitoring System Light Reset useful for you. Good Luck!

(Visited 77 times, 1 visits today)
Tagged with: , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*