Infiniti QX50 TPMS Light Tire Pressure Sensor Warning Reset

Last Updated on February 10, 2020 by Christ

Infiniti QX50 TPMS Light Tire Pressure Sensor Warning Reset – Infiniti continues to innovate. At the New York International Auto Show.2015 2016 Infiniti QX50 is launched. Infiniti says’ 2016 Infiniti QX50 is one of the most luxurious compact crossovers today and become one of the strongest crossovers. The face of this car carries the same appearance with the design language used by Q50 and Q70. The side and rear design of the car is also new.

Many of the LEDs used in cars powered by 19-inch wheels ranging from fog-lamp to the rear lights. 2016 Infiniti QX50 has a 3.2-inch longer wheelbase that makes space into a roomy cabin and cargo space becomes more widespread. QX50 is one of the first luxury compact crossover, one of the hottest segments in the automotive industry today. It was the first vehicle to offer innovative Around View Monitor.

Infiniti QX50 TPMS Light Tire Pressure Sensor Warning Reset

Contents

Infiniti QX50 TPMS Light Tire Pressure Sensor Warning Reset

To turning off the Tire Pressure Monitoring System (TPMS) light on your Infiniti QX50, follow these steps:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.

If the above procedure does not work, try using the following procedure at your own risk!

Time Needed : 17 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. Follow these steps to relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your car:

  1. Adjust the tire inflation pressure recommended on the tire placard located on the door panel.

  2. Locate the TPMS interface plug.

    This is a white female plug that is attached to the OBD II wire loom under the dash. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.
    tire pressure tpms reset

  3. Insert a paper clip or wire to the plug interface.

  4. Turn the ignition ON but do not start the engine

  5. Tap the end of the paper clip on any exposed ground (metal) 6 times.

  6. If the way you are correct, the TPMS warning light will start blinking slowly.

    If it flashes fast that’s not right. If yours isn’t flashing slowly then check your connections, turn the ignition off and start over at step 4.

  7. Once you confirm the lights do not stop flashing, driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.

  8. The light will quickly come back on due to the low tire pressures. Refill your tires to the correct pressure.

Tools
  • Paper Clip or Wire
Materials
  • Infiniti QX50

For more details, please watch the following video:

We got this tutorial from Infiniti specialists. The procedure above can be applied to the latest generations of Infiniti QX50 (2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article of Infiniti QX50 TPMS Light Tire Pressure Sensor Warning Reset useful for you. Good Luck!

(Visited 1,732 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.