2015-2020 Renault Captur Low Tyre Pressure Warning Light Reset

Last Updated on February 1, 2020 by Christ

2015-2020 Renault Captur Low Tyre Pressure Warning Light Reset – Renault Captur is a car produced from 2013 by French carmaker Renault. In 2011 was presented at the Geneva Motor Show the Captur concept, a car of SUV crossover-type characterized by rounded lines, body compact car 4,12 meters in length and height increased from the ground. From there was started a project for the construction of a compact crossover to be attached to the “sister” Nissan Juke. The final car was unveiled on 11 January 2013 and the official presentation took place two months after the Geneva Motor Show.

The original concept incorporates virtually only the frontal styling, with black wider grille in the center to accommodate the automaker’s logo and closer to the sides. The design of the grille is the new styling directed by Laurens van den Acker a couple of years before. Even the headlights are reminiscent of those in the design concept car of 2011, while the bumper partially black plastic gives the overview of the front increased perception of robustness. The side has a rational profile that penalizes the dynamism in favor of convenience: while the Captur concept revealed a sporty personality, the series Captur is more traditional and caters more roominess, which is penalized by the small size of the car.

2015-2020 Renault Captur Low Tyre Pressure Warning Light Reset

2015-2020 Renault Captur Low Tyre Pressure Warning Light Reset:

Time needed: 7 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn turning off or reset the Tire Pressure Monitoring System (TPMS) light on your Renault Captur, follow these steps:

  1. Make sure the vehicle is at a complete stop

  2. Turn the engine switch off

  3. Adjust the tire inflation pressure recommended on the tire placard located on the door panel.

  4. Turn the ignition to the ON position without starting the engine.

  5. Hit the UP or DOWN arrow button on the wash wipe switch and select TYRE PRESSURE : SET TPW

    Renault tyre pressure reset button

  6. Press and hold the UP or DOWN arrow button again to launch the reset.

For more details, please watch the following video:

This tutorial is based on the Renault owner’s manual. This procedure should be work on the latest generation of Renault Captur (2015 2016 2017 2018 2019 2020 model years). Hopefully, the article of 2015-2020 Renault Captur Low Tyre Pressure Warning Light Reset useful for you. Good Luck!

(Visited 7,497 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.