How To Reset Chrysler Sebring TPMS Tire Pressure Sensor Light (2010)
Last Updated on February 6, 2020 by Christ
How To Reset Chrysler Sebring TPMS Tire Pressure Sensor Light (2010) – The Sebring is a car produced by Chrysler from 1995 to 2010. The Sebring came in three generations. The first, from 1995 to 1999, was first available only as a coupe and as a convertible since 1996. The two-body designs did not share many components and sheet metal. The second generation, from 2000 to 2006, the Sebring name is also used in three different cars that added a model four-door sedan, the coupe but was discontinued after 2005.
The third generation was introduced in 2007. Available as a sedan with the convertible version added in 2008. Chrysler Sebring models are exported to European markets. They are also manufactured in China and Russia. The Chrysler Sebring 200C is on sale in Spain since 2007; it is completely new, not an update of the previous Sebring. Chrysler 200 replaces the Sebring starting with the 2011 model.
How To Reset Chrysler Sebring TPMS Tire Pressure Sensor Light (2010)
Time needed: 7 minutes
If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2010 Chrysler Sebring, follow these instructions:
- Make sure the vehicle is at a complete stop
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at least 24 km/h (15 mph), and then verify that it turns off.
NOTE: When filling warm tires, the tire pressure may need to be increased up to an additional 4 psi (30 kPa) above the recommended cold placard pressure in order to turn the Tire Pressure Monitoring Telltale Light off.
This tutorial is based on the Chrysler owner’s manual. The procedure above can be applied to the last generations of Chrysler Sebring (2008 2009 2010 model years). Hopefully the article of How To Reset Chrysler Sebring TPMS Tire Pressure Sensor Light (2010) useful for you. Good Luck!
I drove my car for over 30 miles with tires at the desired pressure and the light is still on.
What now?
Sounds like you have a faulty sensor, battery died or sensor damage.the batteries in the sensors last 5-7 years. If like mine your car shows the pressure missing on the display, on mine I have two tires missing you will probably need to Change the sensors, I got a set of 4 for £125 with a programmer, I am yet to install them but expect it will go without issue.
Like yours i only have tire pressure showing on one tire. I just installed 3 new ones that do not display. Ideas?