How To Reset Infiniti Q60 TPMS Tire Pressure Sensor Warning Light
Last Updated on February 10, 2020 by Christ
How To Reset Infiniti Q60 TPMS Tire Pressure Sensor Warning Light – In the prestigious auto show Detroit Motor Show 2015, the premium brand of Nissan, Infiniti introduced a concept car Q60. In the official statement on Thursday (01/15/2015) in marketing to the wider community, Q60 directly concept introduced by President Infiniti Motor Company Ltd., Roland Kruger. According to him, this concept Infiniti Q60 is the forerunner to the planned premium sports coupe into the mass assembly line in 2016.
See it from the exterior shape which has a sharp corner. The 2-door coupe has a shape that is filled with dynamic charming and able to give the impression of a premium to its customers. The display on the Q60 is a powerful statement of the Infiniti designers, that it is a real excitement. The design is a major factor to bring Infiniti to become stronger. Later, Infiniti Q60 will be equipped with a 3.0-liter V6 engine, direct injection, and twin-turbocharging. The machine claims to be capable of producing maximum power and maximum fuel efficiency.
Contents
How To Reset Infiniti Q60 TPMS Tire Pressure Sensor Warning Light
To turning off the Tire Pressure Monitoring System (TPMS) light on your 2014-2015 Infiniti Q40 / Q60, follow these steps:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 25 mph.
If the above procedure does not work, try using the following procedure at your own risk!
Time Needed : 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. Follow these steps to relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your car:
Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
Locate the TPMS interface plug.
This is a white female plug that is attached to the OBD II wire loom under the dash. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.
Insert a paper clip or wire to the plug interface.
Turn the ignition ON but do not start the engine
Tap the end of the paper clip on any exposed ground (metal) 6 times.
If the way you are correct, the TPMS warning light will start blinking slowly.
If it flashes fast that’s not right. If yours isn’t flashing slowly then check your connections, turn the ignition off and start over at step 4.
Once you confirm the lights do not stop flashing, driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.
The light will quickly come back on due to the low tire pressures. Refill your tires to the correct pressure.
Tools
- Paper Clip or Wire
Materials
- Infiniti Q60
For more details, please watch the following video:
We got this tutorial from Infiniti specialists. The procedure above can be applied to the latest generations of Infiniti Q60 (2014 2015 2016 2017 2018 2019 2020 model years) models. Hopefully the article of How To Reset Infiniti Q60 TPMS Tire Pressure Sensor Warning Light useful for you.
Leave a Reply