Fastest Way To Reset Oil Change Light on Jeep Commander (2009-2010)
Last Updated on December 5, 2020 by Christ
Fastest Way To Reset Oil Change Light on Jeep Commander (2009-2010) – The Jeep Commander is a Sport Utility Vehicle produced by the Jeep car manufacturer from 2005 to 2010. The production model was presented at the New York show in 2005, and production started on July 18 of the same year.
The name Commander was chosen to highlight the military origins of the Jeep brand. The base frame is the same as the Grand Cherokee, a steel monocoque with independent multi-link front wheel suspension and five-link independent multi-link rear suspension.
Fastest Way To Reset Oil Change Light on Jeep Commander (2009-2010)
Time needed: 7 minutes
When you exceed the next scheduled oil change interval, the Oil Change Required light will display in the screen. This indicator system must be reset after performed the maintenance on your vehicle. The easiest way to reset the oil light on the Jeep Commander is by pressing the gas pedal. Here’s how to get started:
- Place the ignition to the RUN position without starting the engine
If your vehicle has the keyless starting system, press the ENGINE START/STOP button twice without pressing the brake pedal
- Fully depress the GAS pedal, three times within 10 seconds
Don’t rush, make sure you press it fully
- Turn off the ignition
Press the ENGINE START/STOP button once
- Verify the indicator has been reset by starting the engine
Done!
These instructions are based on the Jeep Commander owner’s manual. This procedure should apply to the first generation of the Jeep Commander (2009 2010 model years). Hopefully, the article Fastest Way To Reset Oil Change Light on Jeep Commander (2009-2010) can solve your problem. Good Luck!
Leave a Reply