How To Reset Infiniti FX45 QX70 Tire Pressure Sensor TPMS Light
Last Updated on February 10, 2020 by Christ
How To Reset Infiniti FX45 QX70 Tire Pressure Sensor TPMS Light – For the driving enthusiast who is looking for true sporty SUV, the Infiniti QX70 possible S can provide everything you are looking for. Besides appearance, 6 crossbar rim size 21 inches with a dark color became the main feature that distinguishes it from other SUVs on the road. In the market, this car will be faced with the BMW X6, which significantly already famous sporty image.
With all the new packages, QX70S 2015 must abandon the old engine of 5,000 cc V8. All the latest models of Infiniti QX70 S will use the same engine, 3700 cc V6-powered 325 hp and maximum torque of 362 Nm. 7-speed automatic transmission with the manual mode being the only transmission offered in this variant Infiniti. Infiniti also set up rear-wheel-drive variants and AWD. As a luxury SUV that is relatively large, Infiniti QX70 S has very good control accuracy with the support of hard suspension.
Contents
How To Reset Infiniti FX45 QX70 Tire Pressure Sensor TPMS Light
To turning off the Tire Pressure Monitoring System (TPMS) light on your Infiniti FX45 / QX70, follow these steps:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 25 mph.
If the above procedure does not work, try using the following procedure at your own risk!
Time Needed : 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. Follow these steps to relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your car:
Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
Locate the TPMS interface plug.
This is a white female plug that is attached to the OBD II wire loom under the dash. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.
Insert a paper clip or wire to the plug interface.
Turn the ignition ON but do not start the engine
Tap the end of the paper clip on any exposed ground (metal) 6 times.
If the way you are correct, the TPMS warning light will start blinking slowly.
If it flashes fast that’s not right. If yours isn’t flashing slowly then check your connections, turn the ignition off and start over at step 4.
Once you confirm the lights do not stop flashing, driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.
The light will quickly come back on due to the low tire pressures. Refill your tires to the correct pressure.
Tools
- Paper Clip or Wire
Materials
- Infiniti FX45 or QX70
For more details, please watch the following video:
We got this tutorial from Infiniti specialists. The procedure above can be applied to all generations of Infiniti FX series (2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 model years). Hopefully the article of How To Reset Infiniti FX45 QX70 Tire Pressure Sensor TPMS Light useful for you.
Leave a Reply