How To Reset Ford Transit Connect TPMS Tire Pressure Light (2010-2019)

Time needed: 17 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 Ford Transit Connect you must have a TPMS relearn tool and follow these steps:

1. Drive the vehicle above 20 mph (32 km/h) for at least two minutes and then stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.

2. Turn the ignition to the ON position without starting the engine.

3. Turn the hazard flashers on then off 3 times within 10 seconds.

   If the reset mode has been entered successfully, the horn will sound once.

4. Decrease tire pressure for 10 seconds, starting from the driver’s side front tire (LF) until horn sounds.

5. After horn sounds, proceed to the right (passenger’s side) front tire, and repeat the procedure in step 4.

6. Next, proceed as in step 4 for the right (passenger’s side) rear tire and then left (driver’s side) rear tire.

7. After hearing the confirming horn chirp for the left rear tire, training is completed and a message is shown in the information display. Turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.