2005-2013 Chevy Corvette C6 TPMS Tire Pressure Light Reset
Last Updated on February 17, 2020 by Christ
2005-2013 Chevy Corvette C6 TPMS Tire Pressure Light Reset – The Corvette is a sports car produced by the Chevrolet since 1953. It can be considered the first car in this segment in the United States of America, to become the US sports car par excellence. It is still in production.
Thanks to the philosophy that favored mechanical simplicity compared to direct competitors, it resulted in a light, small and relatively inexpensive vehicle. From 2005 to 2012 the Corvette was sold in some countries, including Italy, under the eponymous brand and not with the Chevrolet brand. The sixth-generation, or C6, is the version born in 2005. The car is inspired by a design philosophy that aims to refine and improve the previous C5 rather than to introduce further changes.
2005-2013 Chevy Corvette C6 TPMS Tire Pressure Light Reset:
If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2005 2006 2007 2008 2009 2010 2011 2012 2013 Chevy Corvette C6, follow these instructions:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).
Time needed: 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on 2005 2006 2007 2008 2009 2010 2011 2012 2013 Chevy Corvette C6 you must have a TPMS relearn tool and follow these steps:
- Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
- Turn the ignition to the ON position without starting the engine.
- Press and hold unlock and lock buttons on the Remote Keyless Entry (RKE) transmitter until horn sounds
- Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
- Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
- A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- Turn the ignition off and start the engine to verify the indicator has been reset.
For more details, please watch the following video:
This tutorial is based on the Chevrolet owner’s manual. This procedure should be work on the sixth generation of Chevy Corvette C6 (2005 2006 2007 2008 2009 2010 2011 2012 2013 model years). Hopefully, the article of 2005-2013 Chevy Corvette C6 TPMS Tire Pressure Light Reset useful for you. Good Luck!
Leave a Reply