Infiniti Q70 TPMS Light Tire Pressure Sensor Warning Reset (Without Tool)
Last Updated on February 10, 2020 by Christ
Infiniti Q70 TPMS Light Tire Pressure Sensor Warning Reset (Without Tool) – Infiniti Q70 is a sedan that combines the performance and rides comfort. Luxury sedan, in general, is very concerned about comfort. The convenience factor in the passenger seat into focus, rather than taking care of the driving pleasure behind the steering wheel. This is natural because those owners of luxury sedans will not bother about performance.
But Infiniti does not want to focus on convenience only. When they launched the ‘Infiniti Q70’ recently, they want to try to break the myth that the luxury sedan is not fun to drive. This car is a premium sedan without compromise. Infiniti Q70 tried to penetrate the boundary between a comfortable car with full car performance. This car is no less comfortable with competitors like Lexus and Mercedes-Benz. With growing longer wheelbase, this car guarantee relief lounge in the passenger seat.
Contents
Infiniti Q70 TPMS Light Tire Pressure Sensor Warning Reset (Without Tool)
To turning off the Tire Pressure Monitoring System (TPMS) light on your 2014-2015 Infiniti Q70, follow these steps:
- Make sure the vehicle is at a complete stop
- Turn the engine switch off
- Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
- Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.
If the above procedure does not work, try using the following procedure at your own risk!
Time Needed : 17 minutes
If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. Follow these steps to relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your car:
Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
Locate the TPMS interface plug.
This is a white female plug that is attached to the OBD II wire loom under the dash. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.
Insert a paper clip or wire to the plug interface.
Turn the ignition ON but do not start the engine
Tap the end of the paper clip on any exposed ground (metal) 6 times.
If the way you are correct, the TPMS warning light will start blinking slowly.
If it flashes fast that’s not right. If yours isn’t flashing slowly then check your connections, turn the ignition off and start over at step 4.
Once you confirm the lights do not stop flashing, driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.
The light will quickly come back on due to the low tire pressures. Refill your tires to the correct pressure.
Tools
- Paper Clip or Wire
Materials
- Infiniti Q70
For more details, please watch the following video:
We got this tutorial from Infiniti specialists. The procedure above can be applied to the latest generations of Infiniti Q70 (2014 2015 2016 2017 2018 2019 model years). Hopefully, the article of Infiniti Q70 TPMS Light Tire Pressure Sensor Warning Reset (Without Tool) useful for you. Good Luck!
Leave a Reply