How To Reset Engine Oil Change Light on Ford F450 (2011-2021)

How To Reset Engine Oil Change Light on Ford F450 (2011-2021) – The Ford Super Duty is a full-size pickup truck manufactured and sold by American carmaker Ford. Conventionally, the large F-350 and F-450 of the F series, widely used for commercial purposes, shared the basic design with the slightly smaller F-150.

However, from the 1999 model of the 10th generation F series, it appeared as an independent model designed exclusively. Currently, it is roughly divided into four sizes, F-250, F-350, F-450, and F-550.

How To Reset Engine Oil Change Light on Ford F450 (2011-2021)

Did you get a Engine Oil Change Due Next Service or Oil Change Required message on your 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 Ford F450? This means you must immediately perform oil change on your vehicle. Don’t forget to reset the oil minder system afterward. Depending on your vehicle model, here are a few ways to reset the oil life light.

3rd Generation (2011-2016)

The third generation of Ford F450 was marketed from 2011 to 2016. There are three ways to reset the oil life in this generation. Depending on your vehicle trim level, here are how to reset the engine oil life on the Ford F450 third generation.

With Brake & Gas Pedal

Display Controls Type 1

Follow the steps below if your vehicle is equipped with multi-information display and control buttons on the steering wheel.

• Turn the engine switch to the “ON” position
• Find the SETTINGS menu by using the ▲▼ navigation button and press the OK button to select

• Select VEHICLE
• Select OIL LIFE RESET
• Press and holds the OK button until “Reset Successful” appears on the screen

Display Controls Type 2

After turning on the ignition without starting the engine, press the SETUP button repeatedly until the “OIL LIFE % HOLD RESET = NEW” appears on the screen. Press and hold the RESET button for 2 seconds and release to reset the oil life to 100%.

4th Generation (2017-2021)

The fourth generation is today’s latest models, this generation was introduced since 2017. Depending on your vehicle trim level, here are how to reset the engine oil life on the Ford F450 fourth generation.

With 2″ Display Menu

• Turn the engine switch to the “ON” position
• Find the SETTINGS menu by using the navigation button and press the OK button to select

• Select VEHICLE
• Select OIL LIFE RESET
• Press and holds the OK button until “Reset Successful” appears on the screen

With 4″ Display Menu

• Turn the engine switch to the “ON” position
• Find the SETTINGS menu tab by using the navigation button
• Scroll down and select ADVANCED SETTINGS
• Select VEHICLE
• Select OIL LIFE RESET
• Press and holds the OK button until “Reset Complete” appears on the screen

With 8″ Display Menu

• Turn the engine switch to the “ON” position
• Go to the TRUCK INFO tab menu by using the ◄ ► navigation button
• Scroll down to MAINTENANCE MONITOR and press the OK button to select
• Select OIL LIFE
• Press and holds the OK button until “Reset Successful” appears on the screen

These instructions are based on the Ford F450 owner’s manual. This procedure should apply to the third and fourth generation of the Ford F450 (2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article How To Reset Engine Oil Change Light on Ford F450 (2011-2021) can solve your problem. Good Luck!