Resetting Tire Pressure Monitoring System on Buick Rainier

Resetting Tire Pressure Monitoring System on Buick Rainier – The Rainer was a mid-size SUV produced by Buick from 2004 to 2007. It was introduced in 2004 to replace Oldsmobile Bravada, whose trademark was abolished in the year mentioned above. The Rainer was the first vehicle with these features produced by Buick from the 1920s. In fact, the similar Rendezvous, introduced in 2002, was considered a light truck, while Rainer was part of the truck category. Rainer was the first Buick to have a separate chassis associated with a V8 engine after the 1996 Roadster. Also, again after the latter, Rainer was the first Buick to be rear-wheel drive. The Rainer was available in five-seat configuration and was one of only four SUVs based on GMT360 to offer this configuration coupled with a V8 engine.

The Rainer was available both in rear-wheel drive and in full-drive version. The engine was mounted in front. Among the setup, levels were offered the CXL, which included a better Bose system and XM Satellite Radio. Many features of the Rainer were derived directly from Oldsmobile Bravada, although the front was designed in such a way as to remind the line of Buick models. Buick also debuted with the QuietTuning acoustic insulation system. This system provided triple gaskets for doors, insulating glasses, as well as cushion and engine bonnet covered with thicker sound absorbing the material.

Resetting Tire Pressure Monitoring System on Buick Rainier:

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn, turning off or reset the Tire Pressure Monitoring System (TPMS) light on your 2007 Buick Rainier, follow these steps:

  • Stop the vehicle in a safe place and turn the ignition switch to RUN with the engine off and engage the parking brake.
  • Turn headlight switch from OFF to parking lamps 4 times within three seconds. A double horn chirp will sound and the SERVICE TIRE MONITOR message will be displayed on the Driver Information Center (DIC) to indicate the learn mode is enabled.
  • Increase/ decrease tire pressure for 10 seconds, starting from the driver’s side front tire (LF) until horn sounds.
  • After horn sounds, proceed to the right (passenger’s side) front tire, and repeat the procedure in step 3.
  • Next, proceed as in step 3 for the right (passenger’s side) rear tire and then left (driver’s side) rear tire.
  • After hearing the confirming horn chirp for the left rear tire, turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.

For more details, please watch the following video:

This procedure should be work on all generation of Buick Rainier (2007) models. Hopefully, the article of Resetting Tire Pressure Monitoring System on Buick Rainier useful for you. Good Luck!

(Visited 52 times, 1 visits today)
Tagged with: , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*