2014-2019 Chevy Impala Low Tire Pressure TPMS Light Reset

2014-2019 Chevy Impala Low Tire Pressure TPMS Light Reset – The Chevrolet Impala is a car produced by the American manufacturer Chevrolet since 1959 for the North American market. The first Impala was presented at the Motorama exhibition of General Motors in 1956. These versions showed their new line of vehicles for next year.

This first Impala was a coupe for four passengers, with “a strong Corvette flavor”, which was called Corvette Impala. The show car was made with fiberglass body, like the Corvette. This car takes its name from an artiodactyl mammal called Impala. In 2013 at the New York Auto Show in the USA. presented the Impala 2014.

2014-2019 Chevy Impala Low Tire Pressure TPMS Light Reset

2014-2019 Chevy Impala Low Tire Pressure TPMS Light Reset:

If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2014 2015 2016 2017 2018 2019 Chevy Impala, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2014 2015 2016 2017 2018 2019 Chevy Impala you must have a TPMS relearn tool and follow these steps:

  • Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
  • Place the vehicle in Service Mode by pressing and holding ENGINE START/STOP for more than five seconds
  • Use the five-way DIC control on the right side of the steering wheel to scroll to the Tire Pressure screen under the DIC info page.

  • Press and hold the  button until the horn sounds twice to signal the receiver is in relearn mode
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • Turn the ignition off and start the engine to verify the indicator has been reset.

This procedure should be work on the latest generation of the Chevy Impala (2014 2015 2016 2017 2018 2019 model years). Hopefully, the article of 2014-2019 Chevy Impala Low Tire Pressure TPMS Light Reset useful or you. Good Luck!

(Visited 11 times, 1 visits today)
Tagged with: , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.