2016-2019 Chevy Camaro Low Tire Pressure TPMS Light Reset

2016-2019 Chevy Camaro Low Tire Pressure TPMS Light Reset – The Chevrolet Camaro is a “pony car” built in North America by the American automaker Chevrolet, part of the General Motors group, presented September 26, 1966, as a model of 1967, was designed to compete with the Ford Mustang. The car shares the bodywork and most of the components of the Pontiac Firebird, also introduced in 1967.

Four generations of the Chevrolet Camaro were built until 2002. The fifth generation was presented in 2009 and the sixth was introduced in 2016. On May 16, 2015, Chevrolet introduced the Camaro’s sixth generation in Detroit. The launch, in the presence of all the Camaro of previous generations, coincided with the 50th anniversary of the vehicle. The sixth generation of the Camaro began to be sold at the end of 2015; the car is offered in the LT and SS versions built on the GM Alpha platform in Lansing, Michigan.

2016-2019 Chevy Camaro Low Tire Pressure TPMS Light Reset:

If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2016 2017 2018 2019 Chevy Camaro, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2016 2017 2018 2019 Chevy Camaro you must have a TPMS relearn tool and follow these steps:

  • Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
  • Place the vehicle in Service Mode by pressing and holding ENGINE START/STOP for more than five seconds
  • Use the five-way DIC control on the right side of the steering wheel to scroll to the Tire Pressure screen under the DIC info page.

  • Press and hold the SET button until the horn sounds twice to signal the receiver is in relearn mode
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • Turn the ignition off and start the engine to verify the indicator has been reset.

For more details, please watch the following video:

This procedure should be work on the latest generation of Chevy Camaro (2016 2017 2018 2019 model years). Hopefully, the article of 2016-2019 Chevy Camaro Low Tire Pressure TPMS Light Reset useful or you. Good Luck!

(Visited 7 times, 1 visits today)
Tagged with: , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.