How To Reset Chevy Camaro TPMS Low Tire Pressure Light (2016-2020)

Last Updated on October 16, 2020 by Christ

How To Reset Chevy Camaro TPMS Low Tire Pressure Light (2016-2020) – Equinox is a mid-size SUV crossover produced by Chevrolet since 2005. Equinox is based on the Theta platform of General Motors. The platform is a monocoque. The model is assembled by CAMI Automotive, ie a joint venture between General Motors and Suzuki. It was introduced in 2004 for the 2005 model year.

The second series of the Equinox was announced on December 21, 2008, and was presented to the public Detroit Motor Show in 2009. In 2009, the Team Canada Edition package was available in Canada only. It was marketed on the occasion of the XXI Winter Olympic Games, which took place in Vancouver. This set-up included chrome-plated aluminum alloy wheels, a sunroof, and a premium sound system.

How To Reset Chevy Camaro TPMS Low Tire Pressure Light (2016-2020)

How To Reset Chevy Camaro TPMS Low Tire Pressure Light (2016-2020):

If you receive a low-tire-pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2018 2019 Chevrolet Equinox, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

Time needed: 17 minutes

If you replaced a wheel, tire, TPMS sensor, etc. and are now getting a warning light on your car, then the sensor needs to be reset. To relearn or reset the Tire Pressure Monitoring System (TPMS) sensor on your 2016 2017 2018 2019 Chevy Camaro you must have a TPMS relearn tool and follow these steps:

  1. Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.

  2. Place the vehicle in Service Mode by pressing and holding ENGINE START/STOP for more than five seconds

  3. Use the five-way DIC control on the right side of the steering wheel to scroll to the Tire Pressure screen under the DIC info page.

    chevy tpms reset button up

  4. Press and hold the button until the horn sounds twice to signal the receiver is in relearn mode

  5. Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.

  6. Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.

  7. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position

  8. Turn the ignition off

  9. Set all four tires to the recommended air pressure level as indicated on the tire placard

This tutorial is based on the Chevrolet owner’s manual. This procedure should be work on the latest generation of Chevrolet Equinox (2016 2017 2018 2019 2020 model years). Hopefully, the article of How To Reset Chevy Camaro TPMS Low Tire Pressure Light (2016-2020) useful or you. Good Luck!

(Visited 168 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.