Resetting the Tire Pressure Monitoring System on Chevy Colorado – The first impression that we encountered, the figure of the 2012 All New Colorado LT 2,5L M / T 4×2 has a size larger than the previous model. On the muzzle, dual port grille as the hallmark of Chevrolet looks grim. Especially when combined with two chromium projector style headlamps and a large 16-inch alloy rims.
For the LTZ variant is equipped with square fog lamps chromium, which helps visibility in poor lighting conditions. Furthermore, in the interior, the All New Colorado feels more comfortable and spacious for the driver and passenger side. The backside, more functionalized for goods storage space. While the design of the meter cluster in front of the driver was very thick on the nuances of the Chevrolet Camaro.
Resetting the Tire Pressure Monitoring System on Chevrolet Colorado:
To reset the Tire Pressure Monitoring System (TPMS) sensor on your Chevy Colorado follow these steps:
- Turn the ignition to position On without starting the engine.
- Turn the exterior lamp switch from AUTO to OFF four times within three seconds, until you hear the sound of the horn.
- The horn sounds twice to signal the receiver is in relearn mode
- Starting from the driver’s side front tire, remove the valve cap from the valve cap stem. Activate the TPMS sensor by increasing or decreasing the tire’s air pressure for a seconds, until you hear single horn chirp.
- Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
- A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
- Turn the ignition off and start the engine to verify the indicator has been reset.
For more details, please watch the following video:
This procedure applies only to 2008, 2009, 2010, and 2012 models. Hopefully the article of Resetting the Tire Pressure Monitoring System on Chevy Colorado usefull for you. Good Luck!