Reset Tire Pressure (TPMS) Light on 2005-2016 Ford Escape

Reset Tire Pressure (TPMS) Light on 2005-2016 Ford Escape – Ford is one of the largest automotive company in the world. Many cars Ford entered into various countries in the world. There are several Ford cars that enter the international market, one of which is the Ford Escape. This car became one of the favorites. The material is carried on the Ford Escape is interesting. Ford Escape is tough car with a sporty design and fit for use on terrain or road conditions are severe.

In terms of dimensions and weight, the car is quite dashing on the streets. Ford Escape carrying the kind of inline 4 cylinders, ETCS and VVT DOHC 16V with VICS, bore x stroke (mm) 87. 5 x 94. 0, displacement (cc) 2261, fuel system multipoint sequential electronic fuel injection as well as the ability to tank can contains 61 L of fuel. This powerful car has a strong performance with maximum power (kw / rpm) 157/6000, as well as the maximum torque (nm / rpm) 20. 7/4500.

How to Reset Tire Pressure (TPMS) Light on 2005-2016 Ford Escape:

If you receive a low-tire pressure monitoring system (TPMS) warning light while driving and you want to clear or turning off the warning light on your 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 Ford Escape, follow these instructions:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 2 minutes of cumulative driving at 20 mph (32 km/h).

If you replaced a wheel, tire, TPMS sensor etc. and are now getting a warning light on your car, then the sensor need to be reset. For that you need to purchase the correct TPMS reset tool and follow these instructions:

  • Stop the vehicle in a safe place and turn the engine switch off and engage the parking brake.
  • Press and release the brake pedal.
  • Turn the ignition from OFF to ON position three (3) times ending in the on position without starting the engine.
    • If your car has Smart key button, press once to turn on, then press again to put vehicle into ACC mode, then press again to turn vehicle off. Repeat 2 more times, ending in ACC mode.
  • Press the brake pedal again for 2 seconds, then release.
  • Turn the ignition to OFF position (DO NOT remove the key)
  • Turn the ignition from OFF to ON position three (3) times ending in the on position without starting the engine.
  • If the reset mode has been entered successfully, the horn will sound once.
  • Starting from the driver’s side front tire, place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor.
  • Repeat the procedure on the right-front tire, the right rear tire, and the last one left rear tire.
  • A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position.
  • After hearing the confirming horn chirp for the left rear tire, training is completed and and a message is shown in the information display.Turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.

For more details, please watch the following video:

This procedure should be work on latest generation of Ford Escape (2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016) models. Hopefully the article of Reset Tire Pressure (TPMS) Light on 2005-2016 Ford Escape usefull for you. Good Luck!

(Visited 25,772 times, 1 visits today)
Posted in Tips Tagged with: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*