Reset Low Tire Pressure Light on Nissan Rogue without Scan Tool

Reset Low Tire Pressure Light on Nissan Rogue without Scan Tool – Another of the latest Nissan car, can not be equated with the Mazda CX-5 are attractive to drive or Jeep Cherokee that looks funky. This time Nissan Rogue crossover car that looks as good-looking, functional, efficient and prices are reasonable for its class. Wrapped with comfort and modern package of Nissan overall good impression. Nissan Rogue itself as a global vehicle that is designed to be the twin of Xtrail released for the American market. Where most classes small crossovers easy to drive, as only with this car, which also carry the global platform, Common Module Family (CMF) in architecture.

This new model looks more handsome and stylish, with a stylish front grille tie with the Nissan logo in the middle. This car looks more simple than his car concept model exhibited in 2012 ago at the Hi-Cross show car. With a length of 182.3 inches, the new version look wider (72.4 inches, previous 70.9) and also higher (67.5 Previous 66.3). Nissan Rogue with LED lights on the front and full LED headlamps are available for upper class grade. The standard model with 17-inch alloy wheels and high-end version of the SL uses 18-inch alloy wheels with Dunlop tires P225 / 65R18 all-season tires Grandtrek.

Reset Low Tire Pressure Light on Nissan Rogue without Scan Tool:

To turning off the Tire Pressure Monitoring System (TPMS) light on your 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 Nissan Rogue, follow these steps:

  • Make sure the vehicle is at a complete stop
  • Turn the engine switch off
  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 25 mph.

If the above procedure does not work, try using the following procedure at your own risk!

  • Adjust the tire inflation pressure recommended on the tire placard located on the door panel.
  • Locate the TPMS interface plug. This is a white female plug that is attached to the OBD II wire loom under the dash. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.

Reset Tire Pressure (TPMS) on nissan Infiniti without Scan Tool

  • Insert a paper clip or wire to the plug interface.
  • Turn the ignition ON but do not start the engine
  • Tap the end of the paper clip on any exposed ground (metal) 6 times.
  • If the way you are correct, TPMS warning light will start blinking slowly.
    • If it flashes fast that’s not right. If yours isn’t flashing slowly then check your connections, turn the ignition off and start over at step 4.
  • Once you confirm the lights do not stop flashing, driving for a few miles (kilometers), calibration will complete after 20 minutes of cumulative driving at 16-25 mph.
  • The light will quickly come back on due to the low tire pressures. Refill your tires to the correct pressure.

For more details, please watch the following video:

The procedure above can be applied to latest generations of Nissan Rogue (2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015) models. Hopefully the article of Reset Low Tire Pressure Light on Nissan Rogue without Scan Tool useful for you.

(Visited 7,886 times, 1 visits today)
Posted in Tips Tagged with: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*